7.1 Fundamentals of Safety-Critical Rail Communication

Key Takeaways

  • RSSB Handbook 1 section 9 covers communication by telephone, radio and face-to-face. Identify the right person and repeat the message back to show what you understood.

  • Lead responsibility depends on the roles and task. The signaller leads when speaking to a COSS, while the electrical control operator leads when speaking to the signaller.

  • Use the words “line blocked” to describe an obstructed line. Confirm the line, location and meaning so the parties do not mistake a report of an obstruction for an arranged line blockage.

  • A correct repeat-back verifies what was said. A line blockage still requires the authority number recorded on NR3180 under Handbook 8.

Last updated: November 2026

Start with the right person and purpose

RSSB Handbook 1 Issue 9, section 9 covers how track workers communicate over the phone or radio and face-to-face. Start by making sure you are talking to the right person. Give your location when using a phone or radio, give your name and employer, say what you are doing, and give contact details if needed. The receiver needs enough information to connect a request to the right route, line and work. A job title or a familiar voice alone cannot establish which site the person is calling about.

Lead responsibility

One person must take the lead. The person who starts a call does not necessarily lead it. Use the relationship in Handbook 1 section 9.2. A Controller of Site Safety (COSS) can call the signaller to request a blockage, and the signaller leads that exchange. If the signaller is speaking to the electrical control operator (ECO), the ECO is the lead.

ConversationWho has lead responsibility
ECO and another roleECO
Signaller and another role other than the ECOSignaller
Person in charge of possession (PICOP) and another role other than the ECO or signallerPICOP
Route-setting agent and points operatorRoute-setting agent
Protection controller (PC) and COSSPC
COSS and their workgroup, site warden or lookoutCOSS

Where it is unclear who should lead, or when both people are doing the same task, the person who starts the conversation takes the lead. Taking the lead is a communication duty. It does not transfer a separate operational authority, such as the right to grant a line blockage or the right to let a group enter a work site.

Hear, repeat and resolve differences

As the receiver, make sure you understand the message and repeat it back so the other person can check that understanding. As the sender, listen for mismatched lines, signals, times and qualifications. A listener who repeats the right signal number but the wrong line has not established agreement. Correct the error, repeat the necessary information and check the new response. For a line blockage, Handbook 8 specifically requires reading the entry from NR3180 to the signaller to check it. Complete the full grant procedure before relying on the blockage.

Use a clear pace, slightly slower than normal, at normal volume. Speak directly into the mouthpiece and avoid hesitation sounds. Move to a position of safety before using mobile communications equipment and avoid using it if the call would distract you or affect safety. If machinery or a broken transmission obscures part of the message, ask for that information again and resolve the uncertainty before starting any action that depends on it.

Apply the phrase that matches the situation

Handbook 1 uses “Repeat back” to request the entire message again and “Correction” to indicate that the speaker will correct a word or phrase. For a radio on which only one person can speak at a time, “Over” indicates that a reply is expected and “Out” indicates that none is expected. To report an obstructed line, use “line blocked” rather than “not clear”. State the affected line and the actual hazard so the signaller can act on the report. A verbal acknowledgment such as “OK” does not establish what was received.

Worked example: the wrong line is repeated

The COSS calls about the Up Fast between two named signals. The other person repeats the same identifiers but says Down Fast. The COSS keeps the group in safety and asks to confirm the line, both limits and the relevant protection. The parties resolve the conflict and read back the correct details. The group still waits while the signalling and any agreed additional protection are set up. The signaller then provides an authority number, which the COSS records. The COSS must complete the worksite arrangements and brief the group before work. The critical decisions are to catch the wrong line early and to recognise that a clear conversation and a granted blockage are separate steps.

Suppose two COSSs call each other to resolve which group is ready to leave a shared protection arrangement. If both are doing the same task, the caller takes the lead. When they speak to the protection controller about whether the blockage is still needed, the protection controller leads. Identify the person and the purpose before assuming which rule applies.

Loading diagram...
Checking a Safety-Critical Message
Test Your Knowledge

When a signaller is speaking with the electrical control operator about an electrical safety issue, who has lead responsibility under Handbook 1?

A

The electrical control operator

B

The signaller in every conversation

C

The COSS who originally identified the issue

D

Whoever will record the conversation

Test Your Knowledge

Why must the receiver repeat back a safety-critical message?

A

To confirm that the phone can record the conversation

B

To transfer the sender’s operational authority to the receiver

C

To let the sender check that the receiver understood the message, including the relevant limits

D

To give the workgroup time to enter the site

Test Your Knowledge

A signaller has given an instruction, but interference masks a signal identifier. What should the COSS do before acting on the instruction?

A

Guess the identifier using the Safe Work Pack

B

Ask for clarification and verify the complete message before acting

C

Treat the signal as the nearest one of the same type

D

Ask the group to start while the signaller is still speaking

Sections you finish are checked off in the contents.