1.3 Personal Track Safety (PTS) Fundamentals & Trackside Behavior
Key Takeaways
On or near the line includes being on the line or within 3 metres without a permanent fence or structure between you and the line.
On a platform the on-or-near rule applies to engineering or technical work within 1.25 metres of the platform edge.
Under Handbook 1 the minimum distance from a line a train can approach on is 1.25 metres at up to 100 mph, or 2 metres above 100 mph.
A named track space such as the cess, six-foot or ten-foot does not itself establish a position of safety or a permitted walking route.
Identify the place before applying a distance
RSSB Handbook 1 Issue 9, section 1 gives the definitions used by track workers. The four-foot is between the two rails of the same line. The six-foot is the space between lines with the normal track spacing. The ten-foot is a wider space between lines where there are at least three lines. The cess is beside the line, outside the running rails. The names help you describe where you are. They are not exact measurements, and the width and availability of any safe place can change along a route.
You are on or near the line if you are on it or within 3 metres without a permanent fence or structure between you and the line. There is a platform exception. Track workers doing engineering or technical work within 1.25 metres of the platform edge are considered on or near the line. A person crossing at a level crossing is excluded from the on-or-near definition in section 1. The lineside is between the railway boundary and the area on or near the line. A station platform is not lineside.
A position of safety has a different test
Under Handbook 1, measure from the nearest line a train can approach on. If its maximum speed is 100 mph or less, the minimum distance is 1.25 metres. If its maximum speed is over 100 mph, the distance is at least 2 metres. Those figures describe a position of safety under Handbook 1. They do not by themselves authorise a walking route or a method of working at that distance. Handbook 7 requires the COSS to check the group’s safe system for the walk and for the work. For example, a place 2 metres away may meet a particular position-of-safety test yet still be on or near the line.
| Situation | Decision |
|---|---|
| A worker is 1.5 metres from a 115 mph running line | That does not meet the Handbook 1 position-of-safety distance. |
| A worker is 1.5 metres from an 80 mph line without a permanent fence between them | That meets the Handbook 1 distance from that line for a position of safety, but the location can still be on or near the line. Check all nearby lines and conditions. |
| A route follows the cess but narrows at a structure | Confirm the actual clearance and approved route before moving the group. |
Signs and safe movement
Handbook 1 section 10 distinguishes signs by their meaning. A limited clearance warning tells you that there is no position of safety on that side for the length of the structure. Do not enter or stand there while trains run. A no refuges warning tells you there is no position of safety on that side but there are positions of safety or refuges on the opposite side. It does not authorise crossing to reach one. A prohibition sign says you cannot pass while trains run, except under the specified emergency protection provision, which requires extreme care.
Wear the employer-issued correct high-visibility clothing and use authorised access points and walking routes where provided. Section 4.3 tells a worker crossing while walking alone not to step on rails or sleepers or between movable parts of points. Under section 5.8, a worker in a group may cross an open line only after the COSS has explained the arrangements and confirmed that the worker understands them. Do not infer that the absence of train noise means the line is safe. If a driver sounds their horn, acknowledge it as required by Handbook 1, stay in safety and follow the COSS’s instructions. An acknowledgement to a driver is separate from responding to a lookout or equipment warning.
Worked route check
A group walking beside a 115 mph line reaches a structure with a limited clearance warning. The remaining strip is 1.5 metres from the line. The group stops before the structure and stays in safety. Waiting for one train to pass does not authorise entry while trains remain running. The COSS checks whether there is an approved alternative route that avoids the restriction. If there is none, the group waits in safety while a suitable arrangement, such as having the affected line blocked, is secured. The restriction and the proposed arrangement both need to be checked before the group moves.
What is the minimum distance under Handbook 1 for a position of safety from a line with a maximum speed of 115 mph?
1.25 metres
2 metres
2.75 metres
3 metres
What does the Handbook 1 no refuges warning mean?
The marked side has a refuge for two people
The sign itself authorises crossing to the opposite side
The area is protected whenever a train horn is heard
There is no position of safety on the marked side, but there are positions of safety or refuges on the opposite side
A worker stands 2.5 metres from a running line with no permanent fence or structure between them and the line. How is this location classified under Handbook 1?
It is outside the on-or-near area because the distance exceeds 2 metres
It is on the lineside simply because the worker stands in the cess
It is on or near the line because the distance is within 3 metres
The classification depends only on whether the line is blocked
Sections you finish are checked off in the contents.