6.1 Site Lookouts, Equipment & Appointment
Key Takeaways
On Network Rail infrastructure, COSS (LKT) is a separate competence for planning and delivering work protected by lookout warning. General COSS competence is a prerequisite.
Under RSSB Handbook 3, a lookout wears a white armlet or badge with red LOOKOUT lettering. The lookout has no other duties while looking out.
The appointed site lookout must be able to see approaching trains directly and give the agreed warning in time for everyone to reach safety. Intermediate and distant lookout relays are no longer permitted.
The COSS chooses and tests the warning for the actual work and location. A horn, whistle or touch can be used as briefed; the Rule Book does not prescribe a decibel trigger for a touch warning.
Who can set up lookout warning?
In a Safe System of Work (SSoW) using lookout warning, an appointed site lookout watches for trains and warns the workgroup. The warning gives people time to stop and reach safety. It does not stop trains or make the line safe for work that affects the safety of the line.
On Network Rail infrastructure, Controller of Site Safety (Lookout), COSS (LKT), became a separate competence on 5 December 2025. A person must first qualify as a Controller of Site Safety (COSS). The primary sponsor identifies whether they need COSS (LKT), obtains company director approval and confirms the requirement with the training provider. A person's COSS (LKT) competence and the director-level authorisation for a specific planned lookout arrangement are separate checks. A general COSS should recognise this boundary and query a pack that assigns them a lookout-based arrangement they are not qualified to deliver.
RSSB Handbook 7, Issue 10, in force from 6 December 2025, sets the conditions for the COSS. Handbook 3, Issue 4 sets out the lookout's and site warden's duties. The Network Rail competence notice explains the separate 5 December competence change.
Appointing a lookout
Only use lookout warning when there is no alternative safe system and the arrangement was planned in advance and authorised at director level. The maximum permissible speed of any approaching train must be 25 mph or less. The position of safety must be accessible without crossing an open line and without walking more than 25 metres along the line. Lookouts cannot protect a group walking on or near the line. Do not use them in darkness, in poor visibility or in or near a tunnel. A good sightline does not excuse a failed condition.
Before deploying the lookout, check their relevant competence and that they are correctly identified. Use the Sentinel swipe-in checks to confirm the worker's authority to work before allowing access to the infrastructure. Agree on the line or lines and directions to watch, where the lookout will stand, how they will warn the group, and the position of safety for everyone. If one site lookout cannot cover both directions or warn everyone, assess whether more site lookouts can cover the job directly. Intermediate and distant relays are not an option for extending a short sightline.
| Role | Identification while carrying out the role | What the person watches |
|---|---|---|
| Site lookout | White armlet or badge with red LOOKOUT lettering | Approaching trains on the lines and in the directions briefed |
| Site warden | White armlet or badge with blue SITE WARDEN lettering | Workgroup and boundary of a separated safe area |
| Controller of Site Safety | Blue armlet or badge with white COSS lettering | Whether the safe system is in place and stays effective |
The armlet goes on the left arm; a badge goes on the upper chest. A site warden is not a substitute for a lookout: a site warden warns that someone is about to leave a safe area. A COSS setting up a lookout warning system for a group does not act as a lookout.
Choose and test the warning
Handbook 7 identifies a horn, whistle or touch. The type of work and location determine which warning to use; shouting may supplement it if needed. Test the arrangement before work starts. An audible warning that some workers cannot hear does not pass the test. A touch is a warning given by the site lookout as briefed, not a rule to add a separate relay whenever a noise meter reads a certain value. If a suitable warning cannot reach everyone under the conditions of the task, use a different safe system.
On seeing an approaching train, the lookout gives the agreed warning immediately. If someone does not acknowledge it and move straight to safety, the lookout repeats the touch or gives short, sharp blasts on the whistle or horn, as applicable. If the lookout's view becomes obscured or they cannot give adequate warning, give the warning first and then tell the COSS. The lookout switches off their mobile phone and stays at the post until released or relieved.
Scenario: a request to help the workgroup
Consider a planned, authorised daylight lookout arrangement at a 20 mph site for a task that does not affect the safety of the line. While watching the briefed approach, the lookout is asked to hold a tape measure for a few seconds. Even a small task can divert the lookout at the moment a train becomes visible. The lookout refuses and continues looking. If the team needs additional help or the work can no longer be done as briefed, the COSS stops it and makes sure the group is safe before reviewing the arrangement. Changing a lookout's duties informally would change the safe system.
How is an appointed site lookout identified under RSSB Handbook 3?
A white armlet or badge with red LOOKOUT lettering
A white armlet or badge with blue SITE WARDEN lettering
A blue armlet or badge with white COSS lettering
A high-visibility jacket with no role identifier
During an authorised lookout arrangement, the group asks the site lookout to hold a tape measure. What should the lookout do?
Hold it briefly while watching the approach
Refuse and continue looking out
Help once a train has passed
Ask an unappointed worker to take over temporarily
A site lookout sees an approaching train. The workgroup has rehearsed a touch warning for this arrangement. What does the lookout do?
Wait until a second lookout confirms the approach
Ask the COSS to choose a warning after the train is sighted
Give the agreed touch warning immediately and repeat it if the worker does not move to safety
Switch to a horn without following the briefing
Sections you finish are checked off in the contents.