2.3 OSHA Standards, Safety Data Sheets (SDS) & Blood Exposure Incident Procedures
Key Takeaways
OSHA requires accessible Safety Data Sheets for workplace hazardous chemicals covered by the Hazard Communication Standard.
Use SDS Section 4 for first aid, Section 7 for handling and storage and Section 8 for exposure controls and personal protective equipment.
Employers evaluate whether employees have reasonably anticipated exposure to blood or other potentially infectious materials in assigned work.
Stop a service when bleeding occurs, avoid blood contact, isolate contaminated items and use the applicable first-aid, cleanup and reporting procedures.
If an employee has an occupational exposure incident, the OSHA standard requires immediate availability of a confidential medical evaluation and follow-up after the report.
Use the right safety authority
OSHA’s Hazard Communication Standard, 29 CFR 1910.1200, covers hazardous chemicals in the workplace. Its Bloodborne Pathogens Standard, 29 CFR 1910.1030, applies to occupational exposure, meaning exposure to blood or other potentially infectious materials reasonably anticipated in an employee’s work. The Georgia Board regulates salon services and sanitation. The Environmental Protection Agency (EPA) registers surface disinfectants and publishes product directions. These authorities answer different questions about the same salon incident.
Find and use chemical safety information
An employer must keep the required Safety Data Sheet (SDS) for each covered hazardous chemical readily accessible to employees during each shift. A paper binder and an electronic collection can each work. For electronic access, check that employees can open the correct sheet immediately where they work. The consumer-product exception depends on the way a product is used and on whether workplace exposure duration and frequency exceed the comparable consumer exposure range.
Keep container identification and hazard information available. An alternate container ordinarily needs workplace labeling, subject to the portable-container exception for immediate use by the employee who transferred the chemical. A product’s original label identifies permitted uses. The SDS supplies workplace hazard and first-aid information. An SDS for a different strength or formulation can give the wrong instructions.
| SDS section | What to look up |
|---|---|
| 1. Identification | Product identifier, supplier and emergency contact |
| 2. Hazard identification | Hazards, signal word and other label elements |
| 3. Composition | Ingredients and concentration information where required |
| 4. First-aid measures | Instructions by route, such as an eye splash |
| 5. Fire-fighting measures | Suitable extinguishing media and combustion hazards |
| 6. Accidental release measures | Spill precautions, containment and cleanup |
| 7. Handling and storage | Safe handling and incompatible storage conditions |
| 8. Exposure controls and personal protection | Engineering controls, exposure limits and protective equipment |
| 9. Physical and chemical properties | Properties such as pH, flash point and appearance |
| 10. Stability and reactivity | Incompatible materials and conditions to avoid |
| 11. Toxicological information | Exposure routes and health effects |
| 12–15 | Ecological, disposal, transport and regulatory headings |
| 16. Other information | Preparation or revision date |
OSHA requires the standard headings but does not enforce the content of Sections 12 through 15. For instance, when an employee splashes a chemical into an eye, use Section 4 of the sheet for that chemical for immediate action, and use Section 8 when selecting protection before handling it. For a spill that has not touched anyone, start with Section 6. Use the product’s label and the SDS together when mixing, storing and cleaning up the product.
Prevent and respond to blood contact
Under OSHA’s Universal Precautions, treat all human blood and specified body fluids as infectious for bloodborne pathogens. When differentiating body fluids is difficult or impossible, treat them all as potentially infectious. CDC’s Standard Precautions come from health-care guidance. They address a wider set of potentially infectious materials, including nonintact skin and mucous membranes, and describe infection prevention for patient care. The salon’s legal duties come from the applicable workplace standard and Georgia’s facility rules.
When the employer identifies reasonably anticipated employee exposure, the OSHA standard includes a written exposure control plan, work practices and protection, training, hepatitis B vaccination availability for covered employees, and post-exposure evaluation and follow-up. Apply this standard when handling contaminated work items as well as while providing a service.
When a cut occurs, stop the service and prevent contact with blood. Use gloves when handling contaminated items or helping with first aid. Follow appropriate first aid, including direct pressure with clean gauze and covering a minor wound after bleeding stops. Obtain emergency help for severe or uncontrolled bleeding. Isolate the involved implements and clean up under the applicable rules and the employer’s exposure control plan before the workstation returns to use.
- Surfaces: Clean visible contamination using appropriate protection. Choose an EPA-registered disinfectant labeled for the surface, use site and relevant bloodborne pathogens, and use the label’s contact time.
- Tools and waste: Apply Georgia’s separate implement reprocessing and waste rules. Use a designated sharps container for blades. Use the labeled container for contaminated disposable implements and the separate closed, labeled container for bloody linen. OSHA’s regulated-waste provisions require a second container in specified circumstances such as outside contamination of the primary regulated-waste container.
- Worker exposure: Remove gloves safely and wash hands. Wash contaminated skin with soap and water and flush exposed mucous membranes with water promptly, as the OSHA standard specifies. Report a contaminated sharps injury or blood contact with eyes, mouth or nonintact skin right away. The employer must make confidential medical evaluation and follow-up immediately available after a reported exposure incident covered by the standard.
Scenario. A customer’s cut stops bleeding with pressure. The used shears stay out of service until reprocessed. If blood splashed into the employee’s eye, cleanup of the chair is only one task. The employee also needs to flush the eye, report the incident and obtain the confidential evaluation the employer must make available. Handle the injury, environmental contamination and employee exposure according to their different risks.
Sources checked November 16, 2026. OSHA Hazard Communication Standard, OSHA Bloodborne Pathogens Standard, CDC health-care precautions, EPA List S, Georgia Chapter 240-4, and American Red Cross first-aid manual.
Which SDS sections should a salon worker consult for first-aid measures and exposure controls or personal protective equipment, respectively?
Sections 1 and 5
Sections 4 and 8
Sections 2 and 11
Sections 3 and 9
Which workplace situation is an OSHA bloodborne-pathogens exposure incident requiring a report and prompt evaluation under a covered employer’s plan?
A workplace disinfectant causes an odor without any blood contact
An employee notices a blood stain on a towel without handling it
A used blade punctures an employee’s skin and may carry the client’s blood
An employee sees an empty sharps container
A cosmetologist nicks a client’s scalp. What should the cosmetologist do first?
Stop the service and prevent contact with the blood
Finish the cut so the client can leave sooner
Disinfect the shears while the client remains unattended
Put all used supplies, including the shears, in an ordinary trash bag
Sections you finish are checked off in the contents.