4.2 Infection Control, Universal Precautions & Sharps Safety
Key Takeaways
Apply Standard Precautions to each patient and add precautions appropriate to the exposure and pathogen.
Use safe sharps transfer and disposal. OSHA limits recapping and specifies a mechanical or one-handed method for a permitted exception.
Begin first aid and obtain occupational evaluation promptly. Follow the distinct recommendations for HIV, HBV and HCV.
The 2025 occupational HIV guideline calls for final testing at 12 weeks and conditional interim testing at weeks 4–6.
4.2 Infection Control, Universal Precautions & Sharps Safety
Plan precautions before the case and protect staff while handling blood, sharps and contaminated materials. Select biological protective equipment according to expected contact, splashes and the patient's precautions. Radiation shielding and dosimetry have separate purposes (§10.2).
Apply the correct precautions
Standard Precautions apply across patient encounters. Use hand hygiene and the combination of gloves, gown and face or eye protection appropriate for the expected exposure. Transmission-Based Precautions supplement them when indicated. Follow the infection-prevention assignment for the pathogen and clinical setting.
| Precaution | Practical implications |
|---|---|
| Contact | Use the indicated gown and gloves, and control contamination of shared surfaces and equipment. Use a disinfectant with the relevant label claims and contact time. |
| Droplet | Use the indicated mask on entry. Coordinate source control and transport with the receiving team. Additional eye protection may be needed for splashes or under pathogen-specific instructions. |
| Airborne | Use designated airborne infection isolation and appropriate respiratory protection, such as a fit-tested N95 when indicated. Coordinate essential transport and urgent procedures with infection prevention. |
An ordinary positive-pressure room does not provide airborne isolation. For an urgent procedure involving suspected airborne infection, coordinate location, respiratory protection, patient source control as feasible and room clearance. The clearance interval depends on actual ventilation and the applicable criterion. For example, the CDC table estimates 23 minutes for 99% and 35 minutes for 99.9% removal at 12 air changes per hour when the source is absent and the air mixes perfectly. These estimates do not establish the release time for an unverified procedure suite.
Prevent and manage sharps injuries
OSHA's Bloodborne Pathogens Standard requires an accessible written exposure control plan with at least annual review. Follow standard engineering and work-practice controls, such as safety-engineered devices and sharps containers near use. A designated neutral zone lets team members place and pick up a sharp separately. Agree on the location and announce placing or removing a sharp. Make the container closable, puncture resistant, leakproof on the sides and bottom, and appropriately labeled or color coded. Keep it upright and replace it before overfilling. Follow the manufacturer's fill line.
Avoid recapping contaminated needles. OSHA permits bending, recapping or removal only if the employer can demonstrate no feasible alternative or a specific procedure requires it. In that exception, use a mechanical device or a one-handed method. Employers must offer hepatitis B vaccination at no cost to eligible occupationally exposed employees within 10 working days of initial assignment, after required training, with exceptions in the standard. The number of vaccine doses varies by product and schedule.
If a sharp punctures the skin, wash with soap and water. For a splash to a mucous membrane, flush immediately. Report promptly and contact occupational health or the emergency service under the facility's plan. Follow workplace procedures for documented exposure and confidential source and worker evaluation. Clean blood spills with appropriate protective equipment and an approved disinfectant as directed by its label and facility policy. Use regulated waste containers for sharps and other covered material. A dry stain alone does not establish that a material will release blood when compressed or handled.
Understand pathogen-specific follow-up
| Exposure | Current U.S. teaching |
|---|---|
| Human immunodeficiency virus (HIV) | Evaluate immediately for postexposure prophylaxis (PEP). When indicated, the 2025 U.S. Public Health Service guidance recommends starting as soon as possible, up to 72 hours, without waiting for source test results. Seek expert advice for a high-risk exposure presenting later. The course is 28 days. Use baseline testing and final laboratory antigen/antibody and nucleic acid testing at week 12 from exposure. Do interim testing at weeks 4–6 if PEP began more than 24 hours after a single exposure or any doses were missed. |
| Hepatitis B virus (HBV) | Review source surface antigen, documented vaccination and vaccine response. Someone with a documented complete series and documented anti-HBs of at least 10 mIU/mL generally needs no HBV PEP. An unvaccinated worker exposed to a positive or unknown source may need hepatitis B immune globulin and vaccine. A documented nonresponder after two complete series with a positive or unknown source needs a different plan, typically two immune globulin doses a month apart. |
| Hepatitis C virus (HCV) | CDC does not recommend HCV PEP. Use baseline anti-HCV with reflex RNA testing if positive. When the source assessment indicates follow-up, use HCV RNA at 3–6 weeks and final anti-HCV at 4–6 months if early RNA testing is negative, with reflex RNA if antibody testing is positive. Adjust for baseline status as directed by occupational health. |
Worked case. A worker with a single HIV exposure starts PEP 30 hours later. This is inside the usual initiation window but later than 24 hours. Under the 2025 guidance the worker needs the interim test at weeks 4–6 and the final test at week 12. The interim result does not replace the final test.
An operator needs to receive an uncovered sharp during the procedure. The team has designated a neutral zone. How should the transfer occur?
Pass it directly while the receiver is reaching for the item.
Place it on the patient drape beside the puncture site.
Hold the point until the receiver grasps the handle.
Set it in the designated area, announce it and let the operator pick it up.
An exposed worker starts HIV PEP 30 hours after a single occupational exposure, then takes each scheduled dose. Which testing follows the 2025 occupational guidance?
Only baseline testing if doses were taken.
Interim testing at weeks 4–6 and final testing at week 12 from exposure.
Final testing at week 6 with no week-12 testing.
Final testing 12 weeks after the medication course ends.
The sharps container has reached its marked fill line. What is the appropriate next step?
Close and replace it according to its instructions without pushing items down.
Continue filling it until sharps are visible at the rim.
Move it to another room to shake the contents below the line.
Remove an item by hand to make space.
Sections you finish are checked off in the contents.