4. Conducting the Stress Test: Monitoring and Termination

Key Takeaways

  • Staged protocols raise workload step by step - the classic Bruce protocol runs three-minute stages of increasing treadmill speed and grade, starting at 1.7 mph with a 10% grade - and the concept of staged escalation matters more than any vendor's numbers.

  • During exercise the technician keeps the tracing and patient under continuous observation, takes blood pressure at scheduled intervals, tracks heart rate continuously, and asks about symptoms at every stage.

  • The 220-minus-age estimate is one way to report age-predicted maximum heart rate. Reaching 85% alone is insufficient to end a symptom-limited exercise test.

  • An absolute stop requires stopping and promptly alerting the supervisor. Examples include a patient request, sustained ventricular tachycardia, moderate-to-severe angina, and inability to monitor ECG or systolic pressure. Report relative findings promptly for the clinician’s decision.

  • Continue ECG, symptom, heart-rate, and blood-pressure monitoring through recovery. Abnormalities can first appear after exercise, and symptoms or persistent changes can require longer observation.

Last updated: November 2026

Once the baseline is recorded and the provider gives the go-ahead, the test moves to conduct: exercise, monitor, decide, recover. Blueprint tasks 4.2.3 and 4.2.4 map to this section - conducting the test under supervision and recognizing the findings that end it.

Staged Protocols: The Concept

Exercise stress tests use staged protocols: the workload climbs in fixed steps so the heart's demand rises predictably and each step can be compared to the last. The classic and most widely used is the Bruce protocol, which runs three-minute stages on a treadmill, increasing both speed and incline at each stage - stage 1 begins at 1.7 miles per hour with a 10% grade, and each subsequent stage steps the speed and slope upward. A modified Bruce protocol starts at lower workloads, and a ramp protocol raises workload more gradually. Follow the protocol selected for the study. Before beginning, demonstrate how to step onto the stopped treadmill and confirm the patient understands how to signal that they need to stop. When cleared by the supervisor, start at the selected workload and use the planned stage transitions, checking the signal, symptoms, and vital signs. For the exam, understand how staged protocols work and why they exist; do not memorize vendor-specific tables you will never be responsible for selecting.

Continuous Monitoring During Exercise

During every stage, three monitoring streams run at once:

  • The EKG tracing - watched continuously on screen and printed periodically per protocol. You are watching for the machine's alerts and for obvious visual changes - ST-segment depression or elevation appearing where the baseline tracing was flat - and you report them immediately. The provider interprets what those changes mean; ST deviation is interpretation territory, recognition-and-report is yours.
  • Blood pressure, measured at scheduled intervals (commonly during the last half-minute of each stage) with the secured cuff and tubing from the preparation setup.
  • Heart rate, tracked continuously on the monitor, with the count confirmed against the tracing each stage.

And a fourth stream that is not on any screen: the patient's voice. Ask about symptoms at every stage with a consistent question set - any chest, jaw, or arm discomfort? dizziness? shortness of breath? how does the effort feel? - and record the answers. Tell the supervisor promptly when a patient reports a new symptom, even if the monitor has no alert.

Target Heart Rate Concepts

A common estimate of maximum heart rate in beats per minute is 220 minus age in years. For a 50-year-old, that gives 170 bpm. If the protocol tracks 85% of predicted maximum, the reference is 0.85 × 170 = 144.5 bpm, or about 145 bpm. The estimate varies across individuals, and medications such as beta blockers can blunt the exercise heart-rate response. In a symptom-limited exercise test, reaching the reference by itself does not determine when to stop. Report the rate, symptoms, workload, and tracing to the supervising team.

Termination Indicators: Absolute Versus Relative

CategoryExamplesTechnician response
Absolute: stop and notify promptlyPatient request to stop, sustained ventricular tachycardia or an arrhythmia compromising output, moderate-to-severe angina, dizziness or near-syncope suggesting central nervous system symptoms, pallor or cyanosis suggesting poor perfusion, or monitoring failureTerminate exercise as directed by the safety protocol, alert the supervisor, remain with the patient, and activate the emergency response if indicated
Absolute: ECG or pressure findings under the exercise standardNew ST elevation above 1 mm in leads without prior infarct Q waves, excluding aVR, aVL, and V1; systolic pressure drops by more than 10 mm Hg despite rising workload and there is other evidence of ischemiaCall out the measured change and its context. Stop and escalate under the protocol. The clinician interprets the finding.
Relative: report immediately for a decisionSubstantial horizontal or downsloping ST depression, a persistent systolic drop greater than 10 mm Hg below baseline as workload rises without other ischemic signs, increasing chest pain short of moderate-to-severe angina, or limiting dyspnea, fatigue, or leg symptomsReport promptly, continue close observation, and follow the supervising clinician’s decision. A patient’s request to stop or new signs of danger trigger the applicable stop procedure.

Compare a systolic pressure drop while the treadmill workload rises. A drop of 14 mm Hg with new ischemic ECG findings meets an absolute criterion. A persistent 14 mm Hg drop below baseline in the absence of other evidence of ischemia is a relative criterion in the AHA exercise standard. Report both immediately and give the supervisor the pressure, stage, symptoms, and tracing.

Recovery Monitoring

The test is not over when the patient steps off the treadmill. The recovery period gets the same monitoring discipline as exercise itself, for two reasons: some ischemic ST changes and rhythm disturbances appear only in recovery, after the demand surge subsides, and post-exercise hypotension can occur as cardiac output and vascular resistance change after exercise. Follow protocol for the cool-down - a slow walking recovery or a supine recovery per your facility - and continue recording tracing and vitals for the period specified by protocol. The AHA exercise standard describes six to eight minutes of recovery monitoring, with longer observation when symptoms persist or heart rate, blood pressure, or ST segments remain away from baseline. The provider decides when the study is truly complete; the patient does not leave simply because the walking stopped.

Documenting the Test

A complete stress-test record lets the provider reconstruct the study: which protocol and stages were completed and for how long, vital signs and heart rate at each stage and in recovery, the target heart rate and whether it was reached, any symptoms with their exact onset and the stage they occurred on, the reason the test stopped, and the tracings - baseline, each stage, and recovery - all labeled with times. Write what you observed, not what you interpreted: the record says the patient reported chest pressure at stage 3 with 2 mm ST depression noted on the monitor, not that the patient had ischemia.

Emergency Readiness

Because a stress test provokes the heart on purpose, emergencies are a designed-for possibility, not a surprise. Before every test: the crash cart is nearby and checked per facility protocol, an AED is reachable, the team knows the emergency plan, and you know your role in it. The full sequence of recognizing cardiopulmonary distress, calling for help, and delivering basic life support within your training is taught in the emergency response section later in this chapter - and during stress testing that discipline is non-negotiable: never leave a symptomatic patient on or near the treadmill to go find help. Stop the belt, steady the patient, call loudly for the team using the emergency system.

Caution

If the treadmill malfunctions and cannot stop, hit the emergency stop button, support the patient, and call for help - never step away from a moving belt with a patient on it. Equipment failure is an absolute termination trigger precisely because it removes the control that makes the test safe.

Test Your Knowledge

Which finding is an ABSOLUTE indication to stop a stress test?

A

The patient states clearly that they want the test to stop

B

The patient reports mild leg soreness but wants to keep walking

C

The patient breathes faster as exercise intensity rises

D

The patient feels tired at stage two without other symptoms

Test Your Knowledge

Using 220 minus age, a 50-year-old reaches 145 bpm during a symptom-limited exercise test. What should the technician do?

A

End the test automatically because the patient passed 85%

B

Ignore the rate and continue until the patient asks to stop

C

Increase speed independently to bring the rate to 170 bpm

D

Report that 145 bpm is about 85% of the estimated 170 bpm maximum. Follow the supervising team’s instructions and the safety protocol.

Test Your Knowledge

Why does monitoring continue after the patient steps off the treadmill?

A

Monitoring may stop immediately because exercise ended

B

Continue under protocol because ST changes, arrhythmias, or blood-pressure drops can first appear in recovery

C

Continue only while the technician finishes paperwork

D

Continue only if symptoms were reported during exercise

Sections you finish are checked off in the contents.