4. Patient Assessment and Preparation
Key Takeaways
Instruct the patient on the purpose of the test, the preparation required, and what to expect - in plain language, answering questions before you begin.
Record a standard resting ECG supine as tolerated, with limbs relaxed. Use an approved alternate position when needed for safety or comfort and document it.
Prepare clean, dry sites according to electrode and device instructions. Clip excess hair when needed and use gentle abrasion only when instructed.
Remove electrodes gently and help patients sit or transfer safely. If dizziness occurs, prevent a fall, remain with the patient, and promptly notify the care team.
Report acute distress immediately at any point - chest pain, shortness of breath, or dizziness stops the routine and calls the nurse or provider.
Instruct and Assess Before You Prepare
Preparation begins with instruction (Task 2.10). Before touching the patient, explain the purpose of the test, the preparation required of them, and what to expect - in plain language: 'I will place ten small sticky pads on your chest, arms, and legs. The machine only listens to your heart's natural electricity - it does not send any electricity into you - and the recording itself takes under a minute. I will need you to lie still and stay quiet while it records.' After explaining, ask what the patient needs to be comfortable and check that they understand when to hold still. Invite questions and answer what is in scope; anything about what the results might mean belongs to the provider.
While you instruct, assess. A brief look and a few questions are a safety screen: Are there new or worsening symptoms right now - chest pain, shortness of breath, dizziness? Does the patient appear pale, sweaty, or confused? If anything suggests acute distress, stop the routine preparation, keep the patient safe, and notify the nurse or provider immediately. An EKG ordered STAT for chest pain is exactly the situation where this matters most.
Positioning: Standard Supine
The standard position for a 12-lead EKG is supine - the patient lies flat on the back, head supported by a small pillow if desired, arms at the sides, legs uncrossed (Task 2.11). During capture the patient must be still and quiet. Every element has a reason:
- Legs uncrossed - crossing legs tenses thigh and pelvic muscles, and that tension broadcasts tremor artifact into the limb leads.
- Arms at the sides - raised or propped arms change limb-lead geometry and add muscle tension.
- Still and quiet - movement and talking create somatic tremor artifact; even chewing gum or shivering shows up on the tracing.
Use the standard supine position for a routine comparison when the patient tolerates it. Elevation or rotation can change recorded amplitudes and axes, so document changes in position.
When flat is not tolerated, adapt rather than force:
| Situation | Position |
|---|---|
| Standard 12-lead | Supine, flat, arms at sides, legs uncrossed |
| Cannot lie flat (shortness of breath, heart failure, back pain) | Semi-Fowler's - head of the bed raised roughly 30 to 45 degrees |
| Late pregnancy with discomfort or lightheadedness lying flat | Notify the care team and use its positioning plan, such as leftward tilt. Document the position. |
| Tremor or limited mobility | Support and relax the limbs as tolerated. Use approved adjustments and document them. |
Record any non-standard position on the tracing. A recording taken at 45 degrees is not identical to one taken flat, and the interpreter needs to know which they are reading.
Skin Preparation
Good electrode contact is the difference between a diagnostic tracing and a rerun (Task 2.12). The outer skin layer resists the tiny cardiac electrical signals, and oils, lotions, sweat, and hair all interfere with adhesion and conduction. Prepare each electrode site in this order:
- Expose and drape - undress to the waist under a gown, keep a sheet across the lap, expose only the areas you are working on.
- Clip excess hair at the electrode sites with electric clippers if hair prevents adhesion. Never shave with a razor: razor nicks break the skin, hurt, and invite infection.
- Clean each electrode site using a preparation method approved for the electrodes and recorder. Products differ in which skin cleaners they allow.
- Dry fully. Wait until the site is dry before applying the electrode.
- Abrade gently only if indicated in the instructions and appropriate for the skin. The aim is good electrode contact with no skin injury.
- Check electrode freshness - in-date, sealed packets, gel moist. Discard dried-out or expired electrodes; press each electrode flat with gentle pressure around the adhesive edge.
After the Test: Assist, Don't Abandon
The test is not over when the machine prints (Task 2.13). Remove every electrode gently: press the surrounding skin taut and peel slowly and low toward the adhesive - pulling fast or lifting straight off can tear fragile skin, especially in elderly patients. Wipe away remaining conductive gel with a tissue or cloth.
Then assist the patient:
- Raise the head of the bed and let the patient sit up slowly; lying flat, then standing abruptly, can drop blood pressure and cause dizziness.
- Help the gowned, weak, or elderly patient with gown ties and any clothing; stay within arm's reach until they are steady.
- Apply fall precautions: feet on the floor before standing, call light within reach, and a report to the nurse if the patient is dizzy, lightheaded, or unsteady.
- Thank the patient and tell them what happens next - 'Your tracing goes to Dr. Patel now; your nurse can tell you when to expect results.'
Scenario: The Dizzy Elderly Patient
You finish a tracing on an 84-year-old who has been flat for ten minutes. When you raise the head of the bed she says the room is spinning. You do not walk her to the lobby: you help her stay in a safe supported position, remain with her, and notify the nurse promptly. Follow instructions for vital signs and assistance and use the emergency response if she deteriorates. Wait for safe transfer clearance before helping her stand. The tracing was excellent; the exit was the part that prevented the fall.
Wheelchair and Gurney Adaptations
Patients who cannot transfer to a bed still deserve a diagnostic-quality tracing. For a wheelchair patient, stabilize the chair, support the limbs, apply limb electrodes at approved limb sites, and record the patient’s position. Document any alternate placement required by protocol. For a gurney (stretcher) patient, lock the wheels, use rails and transfer assistance according to fall-prevention policy, and record the position actually used. In both cases the rule is the same: minimize muscle tension, keep the patient safe from falling, and document the position so the interpreter reads the tracing correctly.
Which positioning statement is correct for a standard 12-lead EKG?
Lower the head of the table to strengthen the signal
Have the patient sit upright with both arms above the head
Use a relaxed supine position as tolerated. If a different position is needed, follow the facility procedure and document it.
Ask the patient to cross the legs
Which skin preparation sequence is correct for a patient with a hairy, slightly oily chest?
Clip excess hair at the sites if needed, clean them with an approved method, dry fully, and apply fresh electrodes. Use gentle abrasion only as instructed.
Use a razor and place electrodes on wet skin
Tape the electrodes over the hair
Apply electrodes first, then clean around them
After you finish a tracing, the elderly patient becomes dizzy while sitting up. What is the correct action?
Leave to file the tracing
Keep the patient in a safe supported position, stay with her, and notify the nurse promptly before attempting to stand or transfer her
Stand her up quickly
Give coffee to change the blood pressure
Sections you finish are checked off in the contents.