Free IN Plumber Exam Prep

Vent sizing, developed lengths, vent terminals, roof penetrations, Indiana frost closure rules, wet venting, circuit venting, combination waste and vent systems, and air admittance valves.

Drainage fixture unit (DFU) values, horizontal fixture branches, building drain and sewer sizing, minimum slopes, cleanout locations, sumps and ejectors, and testing methods.

Water service sizing, water supply fixture units (WSFU), distribution pipe sizing, cross-connection control, backflow prevention devices, pressure regulators, and thermal expansion.

Minimum fixture requirements (Indiana defers to Chapter 29 of the Indiana Building Code), fixture setting and clearances, flushometer valves, scald-prevention shower valves (ASSE 1016/1017), traps, and interceptors.

Reading plumbing isometrics and riser diagrams, calculating developed pipe lengths, fitting allowances, 45-degree offset calculations, and rolling offset geometry.

Piping protection against freezing and corrosion, Indiana Table 305.6.2 county bury depths, trenching and bedding, structural notching and boring limits, and Table 308.5 hanger spacing.

Water heater sizing, locations, temperature and pressure (T&P) relief valves, discharge piping termination, draft hoods, combustion air, and drain pans.

Indiana rainfall rates, projected roof area calculations, vertical conductors, roof drains, horizontal storm drains, and subsoil drainage sump pumps.

Indiana Plumbing Commission statutes (IC 25-28.5), licensing rules (860 IAC), 2012 Indiana Amendments (675 IAC 16-1.4), permits, inspections, and contractor responsibilities.