21.5 Bedside Sampling, Infusion Setup, and Safe Transfers

Key Takeaways

  • Use the approved meter and correct swab kit, record what was actually sampled and confirm unexpected results in context.

  • Prime and trace the prescribed infusion under direct supervision. Stop it promptly if extravasation is suspected and follow the infusate-specific pathway.

  • Reassess mobility and the environment before moving a frail person, and use the current care plan, approved equipment and trained staff.

Last updated: November 2026

Measure and interpret bedside glucose

Use the approved point-of-care meter, unexpired strips for that model and the service's quality controls. Confirm the patient's identity, explain why the result is needed and clean your hands. The sample site should be clean and dry. Use a new single-use safety lancet, dispose of it immediately in the sharps bin and apply enough blood to the strip as the device directs. A shared meter needs cleaning and disinfection according to its instructions and local infection prevention policy. Record the value in mmol/L, the time and specimen type, the relationship to meals or treatment when relevant, and the response. If the strip gives an error, check the device, strip and technique and repeat as directed rather than interpreting the error as a patient result.

Interpret a result with symptoms and circulation. Poor peripheral perfusion can make a finger-prick result misleading. A patient in shock or with a result that conflicts with the clinical picture needs prompt assessment and confirmation using a suitable venous or arterial sample or laboratory measurement, following local policy and the device's approved sample types. Treat an urgent clinical problem while obtaining confirmation. In an adult with diabetes on an acute ward, the HSE hypoglycaemia guideline acts on glucose below 3.9 mmol/L even when symptoms are absent. Treatment depends on alertness, ability to swallow and other clinical factors. Use the separate local protocols in emergency or critical care settings. A bedside glucose is helpful for immediate decisions but does not replace the laboratory or clinical criteria for diagnosing diabetes or a hyperglycaemic emergency.

HSE glucose measurement basics · HSE Mid West laboratory manual and point-of-care governance · HSE adult hypoglycaemia guideline · Paired capillary and arterial point-of-care measurements.

Collect and send the specimen the test requires

Check the clinical purpose, sample site, collection kit and laboratory transport instructions before beginning. Use a sterile swab. Protect the sterile tip from your hands or nearby surfaces. Explain how far to insert or where to touch the swab if the patient is collecting it, using instructions for that specific kit. Ask the patient to explain back the steps and how to close and return the sample. A routine anterior nasal swab and a nasopharyngeal specimen require different sampling instructions. A bacterial culture swab and a viral or molecular-test collection kit can have different transport requirements.

SiteHow to obtain a relevant specimen
NoseFor an anterior nasal sample, gently insert to the depth and rotate against the inner surface as instructed for that test. Some carriage screens sample both nostrils. Use the specified number of swabs and suitable medium. Treat deep respiratory specimens as a separate technique.
ThroatFor a routine bacterial throat swab, sample the tonsillar area or posterior pharynx and avoid the tongue and uvula. Suspected epiglottitis requires urgent airway assessment without provocative sampling.
SkinSample the relevant lesion or the designated carriage site. A vesicular lesion for virology and intact skin for carriage screening require different specimens and collection instructions.
WoundSwab a representative area when investigating clinical infection and a swab is appropriate. Clean away contaminating material as recommended before sampling. Sample the wound surface and use the specified medium. A deep infection or pus collection may require aspirate or tissue instead.

Place the specimen straight into the correct container, close it and label it at collection. Include required identifiers, site and side where relevant, date and time, test request, relevant symptoms and recent antimicrobial treatment. Send it promptly with the required packaging and temperature. Collect before antimicrobials where feasible. When a patient needs urgent treatment, specimen collection should fit within the treatment timeline. A positive superficial wound swab may reflect colonisation, so interpret it with the examination.

Portlaoise current laboratory handbook · HSE Mid West laboratory manual, October 2026 · HSE wound management guideline.

Set up an intravenous infusion under direct supervision

Check the order, identity, allergies, access and site. Match the solution, drug if any, concentration, vehicle, route, total volume and rate to the prescription. Check compatibility with the line and other solutions, and select an appropriate set and device. A gravity set depends on its drop factor, a volumetric pump controls a programmed volume and rate, and a syringe pump is designed for suitable small-volume infusions. The local policy and device instructions govern how to load and use each one. Use the service's required checking process, including a second trained checker when required.

Use aseptic technique. Spike and prime the compatible set as directed while it is disconnected from the patient. Clear visible air, control free flow with the appropriate clamps, load or set up the device, then trace the tubing from the container to the intended access and make the connection. Check the pump units and settings against the prescription and observe the start of the infusion. If the order is 500 mL over 4 hours on a volumetric pump and there is no special programming instruction, the rate is 500 ÷ 4 = 125 mL/h. Document the start, ordered rate and volume. Monitor the patient, site, progress and alarms. Resolve an alarm's cause before resuming and assess changes in fluid balance or condition according to the prescribed plan.

New pain, swelling, blanching or leakage at the site suggests extravasation or tissue infiltration. Stop the infusion promptly, disconnect its tubing and keep the cannula initially in place without flushing. Escalate promptly to the clinical team and follow the specific infusate's local management pathway, including decisions about aspiration, antidotes or compresses.

Example volumetric pump instructions, BD Alaris GW 800 · HSE extravasation safety supplement.

Test Your Knowledge

A monitored peripheral IV infusion has just started. The patient reports new burning pain and there is swelling around the cannula. You suspect extravasation. Which immediate action fits the HSE safety guidance?

A

Flush the cannula with saline to check patency

B

Remove the cannula first while the infusion continues

C

Stop the infusion, disconnect its tubing, leave the cannula in place initially without flushing, and escalate

D

Reduce the rate and reassess when the prescribed volume has been delivered

Reassess the transfer before moving a frail patient

Use the patient's moving and handling plan. Reassess before each move. Check present mobility, pain, weight-bearing restrictions, ability to understand and participate, falls risk and any recent change. Explain the move and agree what the patient can safely do. Arrange trained staff, an approved transfer device or hoist and a clear route. Check the device and sling against the care plan and manufacturer instructions. Prepare the surfaces and protect tubing, drains and vulnerable limbs from pulling or pressure. For objects, assess the task, the person doing it, the load, the environment and other controls, including whether a trolley can remove the need to lift.

Worked decision. A frail patient who usually stands with assistance becomes dizzy and can no longer bear weight reliably before a bed-to-chair transfer. Pause and assess the deterioration. Reassess the handling plan and obtain the appropriate team and equipment before resuming a planned transfer. An extra pair of hands does not make an improvised lift safe. If the patient has fallen or may have a new injury, first use the appropriate clinical and trauma assessment. The Council workbook expects supervised competence. It lists routine swabbing, bedside glucose and people handling for indirect supervision and infusion setup for direct supervision.

HSE manual handling and people handling guidance.

Test Your Knowledge

A frail inpatient becomes dizzy before a routine transfer and can no longer follow their usual standing plan. There is no immediate external danger. What is the next action?

A

Pause, assess the clinical change and arrange a suitable revised transfer plan with trained help

B

Carry on with the standing transfer because it was safe at the last assessment

C

Ask one colleague to lift the patient by the arms

D

Use the nearest sling without checking its size or the patient's plan

Sections you finish are checked off in the contents.

Congratulations!

You've completed this section

Continue exploring other exams