Free CLRE Exam Flashcards
Memorize 50 essential terms and definitions for the Contact Lens Registry Examination (CLRE). See the term, recall the definition, then flip to check yourself.
A contact lens wearer has poor meibomian gland function. What happens to tear evaporation?
Tears can evaporate faster. Meibomian glands supply oil to the outer tear film, where it slows evaporation.
Filter by Topic
Jump to Card
About These CLRE Flashcards
These 50 flashcards are designed to help you memorize key terms and definitions for the Contact Lens Registry Examination (CLRE). Each card shows a term on the front and its definition on the back—the classic flashcard format for vocabulary memorization. Use these alongside our practice questions to build both recall and comprehension.
Topics Covered
Complete Flashcard Reference
Review every term in this set. Open any term to reveal its definition.
A contact lens wearer has poor meibomian gland function. What happens to tear evaporation?
Tears can evaporate faster. Meibomian glands supply oil to the outer tear film, where it slows evaporation.
What does mucin do at the surface of the eye?
It helps tears spread and adhere to the ocular surface. Even when tear volume is adequate, the surface still needs an even, stable film.
How can a scratch in the corneal epithelium make infection easier?
The epithelium forms the cornea’s outer protective barrier. A break in that barrier gives microbes a way into the cornea.
Which corneal layer pumps excess fluid out of the stroma?
The endothelium, the innermost layer. If it cannot keep up, fluid collects in the stroma and corneal swelling can blur vision.
Where do the bulbar and palpebral conjunctiva lie?
The bulbar conjunctiva covers the exposed sclera. The palpebral conjunctiva lines the inside of the eyelids.
Why is a history of Sjögren syndrome relevant to contact lens wear?
Sjögren syndrome can impair tear production by affecting the lacrimal glands. The resulting dry eye can make lens wear harder to tolerate.
Where does distant light focus in an uncorrected myopic eye versus an uncorrected hyperopic eye at rest?
In front of the retina in myopia and behind it in hyperopia. Minus lenses move the myopic focus back, while plus lenses bring the hyperopic focus forward.
What is the spherical equivalent of −2.00 D sphere with −1.50 D cylinder?
−2.75 D. Add half the signed cylinder to the sphere. This averages the powers in the two principal meridians and leaves out the directional cylinder correction.
What do the K readings on a prefit chart describe?
Keratometry estimates the curvature of the central anterior cornea, typically along the principal meridians. These readings help guide the initial corneal lens selection.
Which measurement gives a map of corneal curvature when central K readings tell only part of the story?
Corneal topography. Its map shows how curvature varies across the measured surface, which helps reveal irregular shape for lens fitting.
Which instrument can capture a cross-section of the fluid gap beneath a scleral lens?
Anterior segment optical coherence tomography (OCT). The cross-section shows the gap between the lens and the cornea or limbus so clearance can be measured.
How do tear breakup time and the Schirmer test differ?
Tear breakup time measures how long the tear film stays intact after a blink. Schirmer strip wetting estimates tear production.
Which slit-lamp filter makes fluorescein glow during a corneal lens assessment?
A cobalt blue filter. Blue light excites the dye so the examiner can see the pattern of tears beneath a corneal gas-permeable lens.
Which bench instrument verifies a rigid lens’s base curve?
A radiuscope measures the radius of the lens’s back optic zone. A lensometer measures optical power.
Why ask about a candidate’s work and hobbies before choosing a contact lens?
Their routine tells you when they need clear vision and how they may use or care for lenses. For example, long screen shifts and dusty work call for different follow-up questions about comfort and wear.
What should happen to a planned trial fitting if the patient has an active eye infection?
Defer the trial and refer the patient to the eye care provider for evaluation. An active ocular infection is a contraindication to routine lens fitting.
Two lenses use the same material. Which transmits more oxygen at a point where one lens is thinner?
The thinner lens has higher oxygen transmissibility (Dk/t) at that point. The material permeability Dk is the same, and the thickness t is lower.
What does a higher modulus tell you about a soft lens material?
It is stiffer and takes more force to deform by the same amount. Modulus describes mechanical behavior, while Dk describes oxygen permeability.
What two components make up a hybrid contact lens?
A rigid gas-permeable center surrounded by a soft skirt. The rigid center supplies the optical surface and the soft skirt helps support and center it.
Where does a scleral lens bear on the eye?
Its landing zone rests on the conjunctiva over the sclera. The lens vaults the cornea and limbus, leaving a fluid reservoir over the cornea.
How does orthokeratology improve unaided vision after the lens comes out?
A specially designed rigid lens temporarily reshapes the cornea. The effect fades after wear is discontinued.
Why can two soft lenses with the same labeled base curve fit differently?
Diameter and the rest of the lens geometry also affect sagittal depth. Compare the actual on-eye fit when switching designs even if the printed base curves match.
Why check corneal coverage with the soft trial lens in different gaze positions?
A lens that looks centered in straight-ahead gaze can lag when the eye moves. Examining coverage in different positions can reveal limbal exposure or excessive decentration.
A soft trial lens barely moves when lifted through the lower lid. What does this suggest?
A tight fit. The push-up test assesses how readily the lens moves and recenters, even when its resting position looks acceptable.
A centered conventional corneal GP trial lens shows bright central fluorescein pooling. What does this suggest?
The lens is steep relative to the cornea, leaving a thicker tear layer centrally. Examine the midperipheral and edge pattern to confirm the fit.
A toric trial lens’s lower mark consistently rotates 12° to your left as you face the patient. What is the calculated axis if the target is 175°?
007°. With consistent left rotation, add 12° to 175° to get 187°. Cylinder axes repeat every 180°, so the equivalent axis is 007°.
Why watch a toric trial lens’s orientation marks through several blinks?
You need to know whether the lens returns to a repeatable position. If the rotation varies from blink to blink, a single axis adjustment cannot reliably align the cylinder.
What does an over-refraction measure once a well-fitting trial lens has settled?
The refractive error that remains with the lens in place. The result helps refine the final lens power.
How does a wearing schedule differ from a replacement schedule?
The wearing schedule tells the patient when and how long to keep the lens on the eye. The replacement schedule tells them when to discard it and start a new one.
A wearer removes a daily disposable lens after a few hours. What should they do with it?
Discard it and use a fresh lens for the next application. Daily disposables are for a single use.
What should you tell a patient about sleeping in contact lenses?
Remove lenses before sleep unless the eye care provider specifically directs overnight wear with an appropriate lens. Sleeping in lenses increases infection risk even when the lens is approved for overnight use.
Why empty the lens case before adding fresh disinfecting solution?
Mixing used solution into a fresh fill reduces disinfection effectiveness. Each storage cycle calls for fresh solution in the cleaned case.
What is sterile saline used for in a reusable-lens care routine?
It rinses lenses when the care instructions call for it. Disinfection requires a compatible disinfecting system.
What has to happen to a peroxide lens solution before the lenses go back on the eyes?
Complete neutralization using the case and method supplied with the product. Follow the full label time because residual peroxide can injure the eye.
When should a wearer remove their lenses before swimming or showering?
Before getting into the water. Even tap water can transfer organisms to a lens, and water can make soft lenses swell and stick to the eye.
Why dry your hands after washing them and before handling contact lenses?
Drying with a clean cloth keeps residual water on your fingers from transferring to the lenses.
How often does CDC recommend replacing a reusable contact lens case?
At least once every three months. A fresh case helps limit contamination that can build up with repeated use.
How can you check that a new wearer can manage lens handling at home?
Have them insert and remove the prescribed type of lens under observation. Have them practice until they can do both safely before taking the lenses home.
What is the immediate action for a lens wearer who develops worsening eye pain or light sensitivity?
Remove the lenses and contact an eye care provider immediately. These can be warning signs of microbial keratitis, which needs prompt evaluation.
A wearer says the lenses feel dry by evening. What should you clarify in the follow-up history?
Ask how many hours after insertion the dryness begins. Documenting when it starts helps relate the symptom to actual wearing time and compare it at the next visit.
A wearer reports itching, mucus, and reduced lens tolerance. Where do you look for the papillae associated with giant papillary conjunctivitis?
Under the upper lid on the tarsal conjunctiva. Evert the lid to inspect the surface that rubs against the lens during blinking.
What does corneal neovascularization look like at a follow-up exam?
New blood vessels extend from the limbus onto the normally avascular cornea. In a lens wearer this can signal inadequate oxygen and warrants assessment of the fit and wear history.
What does 3 and 9 o’clock staining describe in a corneal gas-permeable lens wearer?
Punctate staining at the nasal and temporal corneal periphery. Evaluate local drying, lens centration, and edge design as possible contributors.
What is contact lens–induced corneal warpage?
A change in corneal shape associated with lens wear. It can distort keratometry mires and topography, so measurements may need repeating after a clinician-directed period without lenses.
Which organism should be considered when a lens wearer with suspected keratitis reports swimming in the lenses?
Acanthamoeba, a water-associated amoeba. Water exposure is an important history clue for the evaluating clinician.
How does dimple veiling form beneath a corneal gas-permeable lens?
Tiny trapped air bubbles indent the corneal epithelium. The result is a pattern of shallow dimples visible after lens removal.
Why examine the cornea with fluorescein after removing lenses at follow-up?
Dye can reveal epithelial staining on the bare cornea. The location and pattern help the clinician assess possible causes such as friction, dryness, or a reaction to solution.
Why record the exact new lens parameters after a refit?
They link the next visit’s comfort, vision, and ocular findings to the specific change. Record details such as the new base curve or diameter so the response can be compared with the previous fit.
When must a U.S. contact lens prescriber provide the patient a copy of the prescription?
When the contact lens fitting is complete. Under the FTC Contact Lens Rule, the prescriber gives the copy even if the patient never asks for it.
When does an unanswered seller request passively verify a contact lens prescription under the FTC rule?
After eight business hours from the prescriber’s receipt of a complete verification request, provided the seller gave the prescriber a reasonable opportunity to respond. Count business hours in the prescriber’s time zone.
Frequently Asked Questions
What does the CLRE certify?
Passing the Contact Lens Registry Examination earns NCLE Basic certification in contact lens dispensing. The NCLE Practical exam is a separate exam. State licensing boards set their own requirements for practice.
How many questions are on the CLRE, and how much time do I get?
The computer-based exam has 125 multiple-choice questions and a two-hour time limit. The handbook’s 100-question blueprint describes how the eight content areas are weighted. The exam also includes unscored pilot items.
What score do I need to pass the CLRE?
ABO-NCLE uses a criterion-referenced standard set by a subject-matter panel using the Modified Angoff method. ABO-NCLE does not publish a numeric cut score. Its reported NCLE Basic pass rate of 59.0% describes 2024 exam results.
Do I need work experience or an employer sponsor to register?
ABO-NCLE requires a high school diploma, GED, or equivalent and may make exceptions for high school students in dual programs. Candidates can register directly without employer sponsorship or prior work experience. Check your state licensing board’s rules if you are taking the exam for licensure.
When can I retake the CLRE?
After a first or second unsuccessful attempt, wait at least 14 days from your test date before registering for another attempt. After a third unsuccessful attempt, you must wait 90 days. Each retake requires a new registration.
Which CLRE topics account for the most questions?
Dispensing and follow-up each account for 20% of the ABO-NCLE blueprint. Prefitting is 15%, ocular anatomy and instrumentation each are 12%, diagnostic fitting is 11%, and refractive errors and regulatory and administrative topics each are 5%.
Explore More ABO-NCLE Optician Certifications
Continue into nearby exams from the same family. Each card keeps practice questions, study guides, flashcards, videos, and articles in one place.
More From This Family
Videos and articles for deeper review.