6.2 Diagram, Map Reading & Crime Scene Spatial Analysis
Key Takeaways
- Alberta urban municipal grids follow standardized navigation conventions: Avenues run East-West and Streets run North-South, organized into quadrant systems (NW, NE, SW, SE) around central dividing baselines.
- Line-of-sight analysis uses geometric sightline rays from witness and officer vantage points to identify visual blind spots created by load-bearing pillars, walls, and interior partitions.
- Ballistic Cover stops and absorbs projectile penetration (reinforced concrete, brick masonry, engine blocks), whereas Concealment merely masks visual detection without stopping bullets (drywall, hollow doors, foliage).
- Collision scene reconstruction locates the Point of Impact (POI) via deep asphalt gouges, tire skid mark offsets, and fluid release apexes, while locked-wheel straight skids indicate pre-collision braking.
- Forensic scene mapping employs Rectangular Coordinates (perpendicular baseline offsets) for structured urban boundaries or Triangulation (distance rays from two permanent reference points) for open or irregular environments.
6.2 Diagram, Map Reading & Crime Scene Spatial Analysis
Executive Summary: Spatial intelligence, visual diagram interpretation, and municipal map reading are core competencies evaluated on the Alberta Police Cognitive Ability Test (APCAT). Law enforcement officers must navigate municipal street grids rapidly, interpret crime scene floor plans, determine lines of sight, distinguish ballistic cover from visual concealment, and reconstruct collision sequences from physical roadway marks. This section provides the spatial and geometric foundations necessary to analyze diagrams accurately under test conditions.
Alberta Municipal Grid Navigation & Addressing Systems
Most Alberta cities and towns (notably Calgary, Edmonton, Red Deer, Lethbridge, and Medicine Hat) utilize structured grid systems. Mastering these conventions is essential for rapid spatial orientation on the APCAT.
NORTH [N]
▲
│
NORTHWEST (NW) │ NORTHEAST (NE)
Avenues run E-W │ Avenues run E-W
Streets run N-S │ Streets run N-S
│
WEST [W] ────────────────────────────┼────────────────────────────► EAST [E]
◄── [Centre Street / Baseline Dividing Axis] ──►
│
SOUTHWEST (SW) │ SOUTHEAST (SE)
Avenues run E-W │ Avenues run E-W
Streets run N-S │ Streets run N-S
│
▼
SOUTH [S]
The Standard Alberta Grid Rules
- Avenues Run East-West: Avenues are parallel roadways that travel horizontally across the map (East to West).
- Streets Run North-South: Streets are parallel roadways that travel vertically across the map (North to South).
- The Quadrant System: Municipalities like Calgary are divided into four distinct quadrants: Northwest (NW), Northeast (NE), Southwest (SW), and Southeast (SE).
- North-South Baseline: Centre Street divides East from West.
- East-West Baseline: Centre Avenue (and the Bow River) divides North from South.
- Numbering Progression Rules:
- In the SW Quadrant: Avenue numbers increase as you travel South (away from Centre Ave); Street numbers increase as you travel West (away from Centre St).
- In the NW Quadrant: Avenue numbers increase as you travel North; Street numbers increase as you travel West.
- In the NE Quadrant: Avenue numbers increase as you travel North; Street numbers increase as you travel East.
- In the SE Quadrant: Avenue numbers increase as you travel South; Street numbers increase as you travel East.
Edmonton Addressing Note: Edmonton operates on a centralized grid where the historic intersection of 100th Street and 100th Avenue anchors the system. Avenue numbers increase heading North, and Street numbers increase heading West.
Crime Scene Floor Plans & Line-of-Sight Geometry
APCAT diagram questions frequently present an overhead architectural floor plan of a bank, convenience store, or residence. Candidates must evaluate angles of view, detect blind spots, and identify tactical sightlines.
┌─────────────────────────────────────────────────────────────────────────┐
│ COMMERCIAL CRIME SCENE FLOOR PLAN │
│ │
│ [NORTH WALL] │
│ ┌─────────────────────────────────────────────────────────────────┐ │
│ │ [REAR OFFICE] │ CHECKOUT COUNTER │ │
│ │ │ ┌────────────────────────┐ │ │
│ │ │ │ [CASHIER] [SUSPECT] │ │ │
│ │ │ └────────────────────────┘ │ │
│ ├─────── ─────────┴──────────────────────────────────────────────┤ │
│ │ │ │
│ │ [PILLAR 1] │ │
│ │ (18" Solid │ │
│ │ Concrete) [DISPLAY AISLE 2] │ │
│ │ (Drywall Partition) │ │
│ │ │ │
│ │ [DISPLAY AISLE 1] [WITNESS 1] │ │
│ │ (Solid Steel Shelving) (Customer) │ │
│ │ │ │
│ │ │ │
│ │ [OFFICER ENTRY] │ │
│ │ [SOUTH ENTRANCE] │ │
│ └─────────────────────────┬─────┬─────────────────────────────────┘ │
│ │DOOR │ │
└─────────────────────────────┴─────┴─────────────────────────────────────┘
Line-of-Sight Analysis Principles
- Sightline Rays: Draw a straight geometric line from the observer's eyes to the target. If an opaque architectural structure intersects this ray, a blind spot (visual obstruction) exists.
- Solid Load-Bearing Pillars vs. Partitions: An 18-inch solid concrete pillar completely blocks visual sightlines and laser lines of sight, creating an expanding triangular shadow zone behind it.
- The Fatal Funnel: Doorways, narrow hallways, and stairwells where movement is restricted and an officer is fully exposed to all interior sightlines before gaining visual control.
- Slicing the Pie: A gradual, angular search technique where an officer stands back from an entry threshold and moves in a wide arc to clear a room degree by degree without entering the fatal funnel.
Tactical Distinction: Cover vs. Concealment
A critical judgment and diagram interpretation concept is the non-negotiable distinction between Cover and Concealment.
┌─────────────────────────────────────────────────────────────────────────┐
│ COVER VERSUS CONCEALMENT │
├──────────────────────────┬──────────────────────────────────────────────┤
│ BALLISTIC COVER │ • Stops and absorbs high-velocity bullets │
│ (Life-Preserving Mass) │ • 18" Reinforced concrete structural columns │
│ │ • Solid brick and masonry exterior walls │
│ │ • Vehicle engine blocks and steel axles │
├──────────────────────────┼──────────────────────────────────────────────┤
│ VISUAL CONCEALMENT │ • Hides the body from visual sight ONLY │
│ (Zero Ballistic Value) │ • 1/2" Interior gypsum drywall partitions │
│ │ • Hollow-core wooden doors and clothing racks│
│ │ • Standard vehicle door sheet metal & glass │
│ │ • Bushes, shrubs, and ornamental foliage │
└──────────────────────────┴──────────────────────────────────────────────┘
Core Rule: Drywall partitions and wooden doors provide concealment, not cover. Directing an officer to seek protection behind drywall during an active shooting is a fatal tactical error.
Motor Vehicle Collision Scene Reconstruction
Collision investigation questions require candidates to reconstruct vehicle trajectories, points of impact, and post-collision movements from physical roadway evidence.
COLLISION ROADWAY EVIDENCE SKETCH
[VEHICLE 2 - Traveling Westbound] ──► ──►
──────────────────────────────────────────┬─────────────────────────────
│ [Gouge Marks & Coolant]
│ ★ POINT OF IMPACT (POI)
│
══════════════════════════════════════════╪═════════════════════════════
▲ │
│ [Pre-Impact Locked-Wheel Skids] │
│ (25 meters straight friction) │ [Yaw / Scuff Marks]
│ │ (Curved tire scrub)
│ │ │
──────┼───────────────────────────────────┼──────────┼──────────────────
│ │ ▼
[VEHICLE 1] [FINAL RESTING POSITION]
[Northbound] [Vehicle 1 at NE Curb]
Physical Roadway Evidence Identifiers
| Physical Evidence | Mechanism of Formation | Investigative Significance |
|---|---|---|
| Pre-Impact Skid Marks | Locked, non-rotating tires sliding on asphalt under heavy braking. | Straight, dark, uniform rubber deposits. Establishes minimum pre-impact speed and driver perception-reaction path. |
| Yaw Marks (Critical Speed Scuffs) | Rotating tire slipping laterally while steering through a critical curve. | Curved, striated marks with diagonal striations. Shows vehicle was yawing and out of directional control. |
| Point of Impact (POI) | The exact geographic location on the roadway where vehicles collided. | Identified by deep metal gouge marks (suspension bottoming out), abrupt skid mark crooked offsets, and concentrated radiator fluid / debris apexes. |
| Final Resting Position (FRP) | Where vehicles, victims, or dislodged cargo come to complete rest. | Establishes post-impact trajectory and kinetic energy dissipation. |
Forensic Crime Scene Measurement Methods
To recreate crime scenes accurately for court testimony, forensic investigators use two standardized physical measurement protocols to map evidence to fixed geographic points.
RECTANGULAR COORDINATES METHOD TRIANGULATION METHOD
(Perpendicular 90° Baselines) (Two Permanent Reference Points)
North Baseline (Curb / Wall) RP 1 [Hydrant] RP 2 [Pole]
┌───────────────────────────┐ ● ●
│ │ │ \ /
│ │ (4.2 m) │ \ (6.8 m) /
│ │ │ \ / (5.4 m)
│ ▼ │ \ /
│──────────► ★ [EVIDENCE] │ \ /
│ (8.5 m) │ ▼ ▼
└───────────────────────────┘ ★ [EVIDENCE]
West Baseline (Curb / Wall) [Forms Rigid Triangle]
1. Rectangular Coordinates Method
- Application: Best suited for indoor rooms, standard roadways, and urban intersections with straight, perpendicular curbs or structural walls.
- Mechanism: Establishes two fixed, mutually perpendicular baseline reference lines (e.g., North curb and West curb). Every evidence item is mapped by taking two perpendicular measurements at exact 90-degree angles from each baseline.
2. Triangulation Method
- Application: Mandatory for open fields, irregular park terrain, rural ditches, and complex multi-vehicle collisions where no straight perpendicular curbs exist.
- Mechanism: Selects at least two permanent, immovable Reference Points (RP1 and RP2), such as a surveyed utility pole, fire hydrant, or concrete bridge foundation. Straight-line distances are measured from RP1 to the evidence item, and from RP2 to the same evidence item, creating a mathematically rigid triangle with the known baseline between RP1 and RP2.
- Reference Point Rule: Reference points must be permanent and immovable. Never use transient objects such as parked vehicles, portable construction signs, or snowbanks.
A Calgary Police Service patrol unit in the Southwest (SW) quadrant is dispatched from the intersection of 4th Street SW and 17th Avenue SW to an emergency call at 8th Street SW and 11th Avenue SW. Assuming standard Calgary grid alignment where avenue numbers decrease heading North toward Centre Avenue and street numbers increase heading West away from Centre Street, in what general cardinal direction must the unit travel?
An officer responds to an armed robbery in progress inside a commercial retail store. An assailant armed with a high-powered firearm is standing at the north checkout counter. The officer enters from the south entrance. Between the entrance and the counter are four architectural structures: an unreinforced 1/2-inch gypsum drywall display partition, an 18-inch solid reinforced concrete structural column, a row of hollow wooden clothing racks, and a double-pane glass display case. To establish an observation vantage point providing genuine ballistic cover while maintaining a line of sight to the suspect, where should the officer position themselves?
Forensic investigators are analyzing a two-vehicle collision diagram at a four-way intersection. Vehicle 1 (northbound) and Vehicle 2 (westbound) collided in the center of the junction. On the roadway diagram, investigators document:
Based on collision reconstruction principles, what does the deep asphalt gouge and concentrated coolant pool pinpoint?
A major crimes detective is mapping an outdoor crime scene located in an open, irregular grassy park where no straight curbs, sidewalks, or perpendicular walls exist. The detective discovers a discarded handgun in the grass. To document the precise spatial position of the handgun for court presentation using the Triangulation method, what procedure must the detective execute?