Which three braking systems make up a commercial vehicle air brake system?
Air Brake System Parts
Question · Easy
How does an air compressor governor normally control compressor operation?
Question · Medium
Chapter 1: Air Brake System Components & Foundation Brakes
1.1 Air Brake Fundamentals: The Three Braking Systems
Study guide
At approximately what pressure is the air-tank safety relief valve normally set to open?
Which sequence correctly describes how an S-cam brake applies?
During the Utah CDL air-brake check, when must the low-air warning devices activate?
What does the 'slippery' setting on an older front-brake limiting valve do?
1.2 Air Supply Subsystem: Compressor, Governor & Drive Mechanisms
What normally happens as air pressure falls into the manufacturer-specified 20-to-45 psi range?
Spring Brakes And Parking Controls
How is the yellow, diamond-shaped parking brake control normally operated?
Why should a driver avoid pressing the service brake pedal when the spring brakes are already applied?
Which vehicles does the Utah CDL handbook identify as subject to the late-1990s federal air-brake ABS requirements?
Antilock Braking Systems
Question · Hard
1.3 Air Storage Reservoirs, Filtration & Moisture Management
What should a normal ABS malfunction-lamp check look like when the ignition is turned on?
How is a dual air brake system arranged?
Dual Air Brake Systems
A warning indicates that one circuit of a dual air system has lost pressure. What is the safest response?
What does excessive pushrod stroke on a brake with an automatic slack adjuster indicate?
Inspecting Air Brake Systems
1.4 Foundation Brake Mechanics: S-Cam, Wedge & Disc Systems
When checking a reachable manual slack adjuster with the parking brakes released, what movement indicates that adjustment may be needed?
During the engine-off leakage test with the parking brake released and the service brake not applied, what is the maximum loss rate for a single vehicle?
After the initial pressure drop stabilizes during the applied leakage test, how much may a single vehicle lose in one minute?
What is the applied leakage-test limit for a combination vehicle after the initial pressure drop stabilizes?
1.5 Safety Valves, Operational Gauges & Monitoring Switches
A dual air system has standard-size tanks. What compressor buildup result meets the handbook check at operating rpm?
How should an applicant test the low-air warning devices during the current Utah skills-test procedure?
How is the emergency-brake pop-out check completed after testing the low-air warning?
Which sequence matches the current four-part air brake check in Utah's CDL skills-test handbook?
Chapter 2: Dual Air Systems, Parking Brakes & In-Cab Controls
2.1 Dual Air Brake System Architecture & Safety Isolation
How should a driver check that the parking brake holds the vehicle?
A Utah CDL driver presses the brake pedal, but application is briefly delayed while air travels through the lines. What is this delay called?
Using Air Brakes
Which factors make up total stopping distance for a vehicle with air brakes?
Under the handbook's good-traction example at 55 mph, approximately how far is the total stopping distance for an average driver with air brakes?
2.2 Spring Parking & Emergency Brake Mechanics
What is controlled braking during an emergency stop in a vehicle without ABS?
Why can excessive service-brake use on a long downgrade cause brake fade?
Which procedure matches the handbook's proper braking technique on a long, steep downgrade?
What should a driver do when parking immediately after a steep descent has left the brakes very hot?
2.3 In-Cab Valves, Tractor Protection & Trailer Controls
What component compresses air for the air brake system?
Air Brake Components
What is the typical air compressor governor cut-out pressure range?
At what pressure does the air compressor governor typically cut IN to resume pumping?
What is the purpose of the air dryer in the brake system?
2.4 Modulating Control Valves & Dual Parking Control Valves
What is the function of the wet tank (supply or service reservoir)?
At what pressure does the safety valve in the supply tank typically open to release excess air?
What is the role of the foot valve (also called the treadle or service brake valve)?
What does the brake chamber do?
Chapter 3: Pre-Trip Inspection Protocols & Out-of-Service Criteria
3.1 The Seven-Step Inspection Method & Where Air Brake Checks Fit
Loading more…