On the NCATT AET exam, the unit used to express the rate of flow of electrical current is the ampere. One ampere is defined as the flow of how much charge past a point per second?
Dc Electricity
Question · Easy
OSHA noise limits
Short
How do voltage, current, and resistance relate in a DC circuit?
Introductory and General Requirements
Flashcard
Ohm's Law states the current in a circuit is directly proportional to voltage and inversely proportional to resistance. A 28 VDC aircraft bus supplies a load of 14 ohms. What current flows?
Unit used to express opposition to current flow.
Electrical fundamentals
Guess the Term
Chapter 1: DC Electricity and Circuit Fundamentals
1.1 DC Basic Terms, Atomic Structure, and Charge
Study guide
Cheat sheet
Aircraft storage batteries store energy chemically and deliver it electrically. Most aircraft storage batteries are rated at which nominal DC voltages?
Read the clue and guess the term in 6 tries.
Game
How is electrical power calculated from voltage and current?
Kirchhoff's Voltage Law (KVL) is applied when analyzing a series circuit. KVL states that around any closed loop the algebraic sum of which quantity equals zero?
Question · Medium
Unit of power equal to one joule per second.
A technician measures three resistors of 10 ohms each connected in series across a 30 V source. What is the total circuit current?
Same battery. Which lets more through?
What remains common in a series circuit?
In a purely series circuit, which electrical quantity is the same value through every component?
Value a typical AC voltmeter displays, equal to 0.707 times a sine wave's peak.
1.2 Ohm's Law and Electrical Power
Voltage drop across a resistor is often called an IR drop. A 5 A current flows through a 4-ohm resistor. What is the voltage drop across it?
Swap tiles to line up three of the same term.
Term Match
What distinguishes a parallel circuit from a series circuit?
Electrical power in a DC circuit is found by P = E x I. A landing-light circuit draws 8 A at 28 V. How much power does it consume?
Standard unit of frequency equal to one cycle per second.
Which subatomic particle is negatively charged and is the carrier involved in the conduction of electricity in a conductor?
OSHA fall heights, to scale
What does Kirchhoff's Voltage Law require around a closed loop?
Two 12-ohm resistors are connected in parallel. What is the total resistance of the combination?
SI base unit used to express the rate of electron flow in a circuit.
1.3 Series and Parallel DC Circuits
Alternating current continuously changes in magnitude and periodically reverses direction. The waveform produced by a rotary generator that describes this behavior is a:
Ac Electricity
Flip two cards at a time to find matching terms.
Term Pairs
What does Kirchhoff's Current Law require at a junction?
The RMS (root-mean-square) value of a sine wave is its effective value. The RMS value equals what fraction of the peak value?
Unit expressing how much charge a capacitor stores for each volt across its plates.
In an AC circuit containing inductance, the relationship between current and voltage is described by the memory aid ELI. This means that in an inductor:
What safe sequence isolates a basic circuit fault?
The memory aid ICE describes the phase relationship in a capacitive AC circuit. In a capacitor:
General-purpose two-element semiconductor that permits current in one direction and is used to rectify alternating current.
Semiconductors
1.4 Voltage Drop, Circuit Protection, and Aircraft Batteries
Apparent power in an AC circuit is the product of effective voltage and effective current without reference to phase. In what units is apparent power expressed?
Find five hidden terms in a grid of letters.
Term Search
How are voltmeters and ammeters connected differently?
Resonance occurs in an AC circuit under what condition involving reactance?
Question · Hard
___ gate whose output goes low only when every input is high.
Digital logic
A power factor describes the ratio of true power dissipated to the apparent input power (volts x amps). In a purely resistive AC circuit, the power factor equals:
Loading more…