Which component supplies compressed air to an air-brake vehicle's storage tanks?
Air Brake Components
Question · Easy
In the current Delaware CDL Manual, at about what pressure does the governor cut out and stop the compressor from pumping?
Chapter 1: Air Brake System Components & Foundation Brakes
1.1 Air Brake Fundamentals: The Three Braking Systems
Study guide
At about what tank pressure should the air-compressor governor cut in and resume pumping?
When must manually operated air-tank drains be opened?
Your vehicle has an alcohol evaporator and manual tank drains. What cold-weather maintenance does the manual require?
Question · Medium
What is the purpose of the safety valve in the first tank supplied by the air compressor?
1.2 Air Supply Subsystem: Compressor, Governor & Drive Mechanisms
What happens when a driver presses the air-brake pedal farther down?
Which sequence correctly describes an S-cam brake application?
How does a wedge brake differ from an S-cam brake?
Question · Hard
In an air-operated disc brake, what replaces the S-cam to create clamping force?
1.3 Air Storage Reservoirs, Filtration & Moisture Management
What does an air-brake supply pressure gauge show?
The application pressure gauge shows more pressure is needed to hold the same speed. What can that indicate?
On most air-brake vehicles, when must the visible low-air warning come on?
Why might a large bus's low-pressure warning signal at 80 to 85 psi even though the general threshold is 55 psi?
1.4 Foundation Brake Mechanics: S-Cam, Wedge & Disc Systems
The low-air warning comes on while you are driving. What should you do?
Air Brake Operation
Which statement correctly distinguishes the three braking systems on an air-brake vehicle?
How are spring brakes kept released during normal driving?
Spring And Parking Brakes
At what pressure range does the manual say tractor and straight-truck spring brakes come fully on?
1.5 Safety Valves, Operational Gauges & Monitoring Switches
How is the parking-brake control identified on a newer air-brake vehicle?
Why should you avoid pressing the service-brake pedal while the spring parking brakes are applied?
What does a spring-loaded modulating control valve allow a driver to do?
A bus has dual parking control valves and a separate air tank. What is the separate supply for?
Chapter 2: Dual Air Systems, Parking Brakes & In-Cab Controls
2.1 Dual Air Brake System Architecture & Safety Isolation
What is the safety purpose of a dual air-brake system?
Dual Air Systems
Before driving a vehicle with a dual air system, what pressure must both systems have?
One half of a dual air system loses pressure while the other remains charged. What should the driver expect?
How does the manual tell you to check a manual slack adjuster?
Air Brake Inspection
2.2 Spring Parking & Emergency Brake Mechanics
An automatic slack adjuster has excessive travel. What should the driver do?
Which foundation-brake condition is unacceptable during inspection?
During the static leakage test, how much pressure may a single vehicle lose in one minute?
What is the one-minute static leakage limit for a combination vehicle?
2.3 In-Cab Valves, Tractor Protection & Trailer Controls
With the service brake held firmly down, what is the one-minute air-loss limit for a single vehicle?
During an applied leakage test, a combination vehicle loses 4 psi in one minute. How should that result be judged?
How do you test the low-air warning during an in-cab inspection?
After checking the low-air warning, how do you test automatic spring-brake application?
2.4 Modulating Control Valves & Dual Parking Control Valves
At operating engine rpm, what pressure buildup does the manual expect from a typical dual air system?
How should you test that the parking brake will hold?
What is the correct service-brake road test before entering traffic?
Which manufacture dates trigger the federal ABS requirement described in Section 5?
Chapter 3: Pre-Trip Inspection Protocols & Out-of-Service Criteria
3.1 The Seven-Step Inspection Method & Where Air Brake Checks Fit
Loading more…