All Practice Exams

100+ Free Assam ASSEB HS Skill Subject Electronics and Hardware Practice Questions

Assam ASSEB Higher Secondary Skill Subject Electronics and Hardware Examination practice questions are available now; exam metadata is being verified.

✓ No registration✓ No credit card✓ No hidden fees✓ Start practicing immediately
100+ Questions
100% Free

Loading practice questions...

2026 Statistics

Key Facts: Assam ASSEB HS Skill Subject Electronics and Hardware Exam

3 Hours

Total duration of ASSEB HS Skill theory examination

Assam State School Education Board (ASSEB)

30%

Minimum pass percentage in ASSEB higher secondary theory

ASSEB Board Regulations

100

Syllabus-aligned practice questions in this question bank

OpenExamPrep

Class 11 & 12

Target secondary vocational standard under NSQF level 3-4

ASSEB / AHSEC Vocational Syllabus

Prepare for Assam ASSEB HS Class 11 & 12 Electronics & Hardware with 100 questions on electronic circuits, PCB soldering, appliance repair, DMM testing, and safety.

Sample Assam ASSEB HS Skill Subject Electronics and Hardware Practice Questions

Try these sample questions to test your Assam ASSEB HS Skill Subject Electronics and Hardware exam readiness. Each question includes a detailed explanation. Start the interactive quiz above for the full 100+ question experience with AI tutoring.

1What is the resistance value of a 4-band resistor with color bands Brown, Black, Red, and Gold?
A.1 kΩ ±5%
B.100 Ω ±5%
C.10 kΩ ±5%
D.1 kΩ ±10%
Explanation: Brown = 1, Black = 0, Red multiplier = 10^2 (100), and Gold tolerance = ±5%. Therefore, the value is 10 × 100 = 1,000 Ω or 1 kΩ ±5%.
2According to Ohm's Law, what current flows through a 50 Ω resistor when a DC voltage of 12 V is applied across it?
A.4.16 A
B.0.24 A
C.600 A
D.2.4 A
Explanation: Using Ohm's Law I = V / R, I = 12 V / 50 Ω = 0.24 A (or 240 mA).
3Which type of capacitor is polarized and must be connected with correct positive and negative terminal orientation in a DC circuit?
A.Ceramic capacitor
B.Mylar film capacitor
C.Electrolytic capacitor
D.Mica capacitor
Explanation: Electrolytic capacitors have an oxide dielectric layer formed by electrolysis, making them polarized with designated positive (+) and negative (-) leads.
4What is the typical forward voltage drop across a standard silicon PN junction diode during conduction?
A.0.2 V
B.2.8 V
C.1.5 V
D.0.7 V
Explanation: A silicon PN junction diode requires approximately 0.6 V to 0.7 V of forward bias voltage to overcome the internal barrier potential.
5In which operating region must a Zener diode be biased to function properly as a voltage regulator?
A.Reverse breakdown region
B.Forward active region
C.Cut-off region
D.Saturation region
Explanation: A Zener diode is specifically designed to operate in the reverse breakdown region without damage, maintaining a stable breakdown voltage across a wide current range.
6In what form does an inductor store electrical energy when current passes through its coils?
A.Electrostatic field
B.Magnetic field
C.Thermal energy
D.Chemical potential
Explanation: An inductor stores energy in its surrounding magnetic field when electric current flows through its wire turns, calculated as E = 1/2 * L * I^2.
7A step-down transformer has a primary winding of 1000 turns connected to 230 V AC. If the secondary winding has 50 turns, what is the output secondary voltage?
A.115 V
B.46 V
C.11.5 V
D.460 V
Explanation: Using the transformer voltage ratio formula V_s / V_p = N_s / N_p: V_s = 230 × (50 / 1000) = 230 × 0.05 = 11.5 V.
8Two resistors of values 20 Ω and 30 Ω are connected in parallel across a battery. What is the total equivalent resistance of the combination?
A.50 Ω
B.25 Ω
C.10 Ω
D.12 Ω
Explanation: For two parallel resistors, R_eq = (R1 × R2) / (R1 + R2) = (20 × 30) / (20 + 30) = 600 / 50 = 12 Ω.
9According to Kirchhoff's Current Law (KCL), what is the algebraic sum of all currents entering and leaving a circuit node?
A.Zero
B.Equal to the supply voltage
C.Equal to the total resistance
D.Infinite
Explanation: KCL states that charge is conserved, meaning the sum of all currents entering a junction (node) must equal the sum of currents leaving it, so the algebraic sum is zero.
10What are the three terminals of a Bipolar Junction Transistor (BJT)?
A.Anode, Cathode, Gate
B.Emitter, Base, Collector
C.Source, Drain, Gate
D.Primary, Secondary, Core
Explanation: A BJT consists of three semiconductor regions named Emitter, Base, and Collector.

About the Assam ASSEB HS Skill Subject Electronics and Hardware Practice Questions

Verified exam format metadata for Assam ASSEB Higher Secondary Skill Subject Electronics and Hardware Examination is pending. The practice questions above remain available while official exam length, timing, passing score, fee, and administrator details are reviewed.