100+ Free High Risk Work Licence — Personnel and Materials Hoist (HP) Practice Questions
Pass your Australia High Risk Work Licence — Personnel and Materials Hoist (HP) Assessment exam on the first try — instant access, no signup required.
Loading practice questions...
Explore More Australia High Risk Work Licensing
Continue into nearby exams from the same family. Each card keeps practice questions, study guides, flashcards, videos, and articles in one place.
Key Facts: High Risk Work Licence — Personnel and Materials Hoist (HP) Exam
100
Practice Questions
OpenExamPrep
NAI
Closed / unpublished
Safe Work / regulators
Must-pass
Calcs (typical RTO practice)
RTO/assessor practice
5 yrs
Licence Validity
WHS Regulators
The Australia HRWL Personnel and Materials Hoist (HP) pathway uses a closed-book NAI knowledge and calculation assessment plus practical for CPCCLHS3001. Critical calculations and safety items are commonly treated as must-pass. This prep includes 100 practice questions covering HP vs HM hierarchy (HP covers HM; HM does not cover HP).
Sample High Risk Work Licence — Personnel and Materials Hoist (HP) Practice Questions
Try these sample questions to test your High Risk Work Licence — Personnel and Materials Hoist (HP) exam readiness. Each question includes a detailed explanation. Start the interactive quiz above for the full 100+ question experience with AI tutoring.
1Under Australian WHS law, what is a personnel and materials hoist operator's primary duty of care while performing high-risk work?
2Which High Risk Work Licence class is required to operate a builder's hoist that may carry personnel as well as materials in Australia?
3What national unit of competency underpins the HP personnel and materials hoist High Risk Work Licence assessment?
4According to SafeWork NSW class definitions, what does an HP licence authorise that an HM licence does not?
5How does SafeWork NSW describe a materials hoist (HM) relative to the support structure?
6Which plant configurations are included in the CPCCLHS3001 / HP personnel and materials hoist scope?
7How long is an Australian High Risk Work Licence, including HP, typically valid before renewal is required?
8What is the minimum age typically required to undertake HP high-risk work licence training and assessment in Australia?
9After a Notice of Satisfactory Assessment (NSA) for HP, when must you typically apply to the state regulator for the licence?
10When planning an HP hoist task, what should you do first with unclear work instructions?
About the High Risk Work Licence — Personnel and Materials Hoist (HP) Exam
The High Risk Work Licence for Personnel and Materials Hoist (HP class) is required in Australia to operate a builder's hoist in which personnel, goods and/or materials may be hoisted—covering cantilever hoists, tower hoists, or multiple-winch configurations. Assessment is based on the national unit of competency CPCCLHS3001 — Licence to operate a personnel and materials hoist. It covers planning the task, hazard identification, load-weight checks against working load limit (WLL), pre-start inspections of gates/interlocks/guides/safety devices, safe multi-level operation with personnel and materials, communication, emergency response, and shut-down/securing under Model WHS Regulations Part 4.5. HP is distinct from HM (materials hoist only): under regulator hierarchy HP also covers HM work, but HM does not authorise hoisting personnel.
Assessment
Closed-book National Assessment Instrument (NAI) knowledge and calculations assessment, plus a practical personnel and materials hoist operation assessment, administered by an accredited high-risk work assessor through a Registered Training Organisation (RTO).
Time Limit
Varies by RTO / assessor (closed-book knowledge and calculations, then practical)
Passing Score
Competency-based overall. Candidates are commonly required to answer calculations and safety-critical theory correctly and must demonstrate competent practical operation; exact marking rules sit in the closed NAI.
Exam Fee
RTO training and assessment fees commonly fall roughly in the $650–$950 AUD range depending on provider and duration (examples advertised around $750–$890), plus a separate regulator HRWL application fee (e.g. SafeWork NSW 2026–27: $95 per class for a new licence; renewal and other states/territories differ—check your regulator). (State and Territory Work Health and Safety (WHS) regulators (e.g., SafeWork NSW, WorkSafe Victoria, WorkSafe Queensland).)
High Risk Work Licence — Personnel and Materials Hoist (HP) Exam Content Outline
Plan Work & Hazard Identification
Task planning from work instructions, HP vs HM licence scope and hierarchy (HP covers HM; HM does not cover HP), WHS duties, hierarchy of control, SWMS/risk assessment, site hazards, communication methods, and emergency procedures.
Pre-Start Inspection & Preparation
Data plate and WLL checks, structural and guide inspections, gates and interlocks, overrun/buffer devices, ropes/chains/winches, tagging out defects, and confirming landing controls.
Operate Personnel & Materials Hoist
Load calculation and distribution within WLL, safe personnel boarding, gate/interlock discipline, multi-level stops, materials handling, communication during lifts, fault response, emergency stops, and licence scope limits (operation only—not install/dismantle).
Shutdown & Securing
Safe parking at designated level, isolation of power, securing against unauthorised use, post-operational checks, logbook entries, and reporting faults.
How to Pass the High Risk Work Licence — Personnel and Materials Hoist (HP) Exam
What You Need to Know
- Passing score: Competency-based overall. Candidates are commonly required to answer calculations and safety-critical theory correctly and must demonstrate competent practical operation; exact marking rules sit in the closed NAI.
- Assessment: Closed-book National Assessment Instrument (NAI) knowledge and calculations assessment, plus a practical personnel and materials hoist operation assessment, administered by an accredited high-risk work assessor through a Registered Training Organisation (RTO).
- Time limit: Varies by RTO / assessor (closed-book knowledge and calculations, then practical)
- Exam fee: RTO training and assessment fees commonly fall roughly in the $650–$950 AUD range depending on provider and duration (examples advertised around $750–$890), plus a separate regulator HRWL application fee (e.g. SafeWork NSW 2026–27: $95 per class for a new licence; renewal and other states/territories differ—check your regulator).
Keys to Passing
- Complete 500+ practice questions
- Score 80%+ consistently before scheduling
- Focus on highest-weighted sections
- Use our AI tutor for tough concepts
High Risk Work Licence — Personnel and Materials Hoist (HP) Study Tips from Top Performers
Frequently Asked Questions
What is the difference between HP and HM hoist licences?
HP (Personnel and materials hoist) allows you to operate a hoist that may carry personnel, goods and/or materials—typically a cantilever, tower, or multiple-winch builder's hoist. HM (Materials hoist) only authorises hoisting goods or materials; you cannot hoist personnel. Under SafeWork NSW's high-risk work licence hierarchy, holding HP also authorises HM work, but an HM licence does not cover HP work.
What unit of competency underpins the HP High Risk Work Licence?
training.gov.au lists CPCCLHS3001 — Licence to operate a personnel and materials hoist as the licensing unit for HP. Competence in the unit does not itself issue the HRWL; you must apply to your state or territory WHS regulator (often within 60 days of a Notice of Satisfactory Assessment) for the HP class.
How long is an HP High Risk Work Licence valid?
Australian High Risk Work Licences, including HP, are valid for 5 years and are recognised nationally. You must renew with your state or territory regulator before expiry (renewal windows commonly extend up to 12 months after expiry, after which full re-assessment may be required).
What does the CPCCLHS3001 assessment include?
You complete training with an RTO, then an accredited assessor delivers the closed-book National Assessment Instrument covering knowledge and calculations, plus a practical hoist operation assessment. The unit elements are: plan task; select and prepare equipment; conduct hoist operations; and shut down and secure the hoist. Performance evidence requires three lifts of different weights with stops at three levels including at least one floor.