Under Oregon CDL rules, the Combination Vehicles Test is required for drivers seeking to operate which vehicles?
Oregon Cdl Basics
Question · Easy
POV: the turn is tighter than it looks
Short
A Group A/Class A combination generally means a combination with a GCWR of at least 26,001 pounds and a towed unit over:
What is the best way to reduce rollover risk in a loaded combination vehicle?
Driving Combinations
The “crack-the-whip” effect is mainly caused by:
Oregon Section 6 recommends following at least one second for each 10 feet of vehicle length, plus one extra second when traveling over:
What is off-tracking?
When making a right turn with a tractor-trailer, you should mainly watch for:
Safe Turns
During a left turn in a combination vehicle, why should you monitor the left side carefully?
Before entering a sharp curve with a heavy combination, the safest approach is to:
Speed And Space
Which backing setup is generally preferred for a combination vehicle when available?
Backing
A trailer skid is most often corrected by:
Trailer Skids
What is a jackknife?
The kingpin is:
Coupling
Before backing under a trailer to couple, the fifth-wheel locking jaws should be:
For coupling, the trailer should be set so the tractor must:
A tug test is performed by:
After a tug test, what visual check is still required?
Which line is the emergency or supply line on most tractor-trailers?
Air Electric Lines
Which line carries service-brake control pressure to the trailer?
The trailer electrical cord should be:
Before driving after coupling, landing gear should be:
Landing Gear
When parking a trailer for uncoupling, what surface is best?
Uncoupling
The trailer hand valve should normally be used for:
Trailer Brakes
To supply air to the trailer after coupling, the driver normally:
Which item belongs in the coupling-area inspection?
Inspection
During trailer walkaround, lights and reflectors should be checked because:
Air lines to the trailer should have enough slack mainly to:
At night in a combination vehicle, speed should allow you to:
If equipped with a sliding fifth wheel, the inspection should confirm:
What minimum score is required to pass CDL knowledge tests under federal standards?
After coupling, you see space between the trailer apron and fifth wheel. What is the safest conclusion?
Question · Medium
Oregon Section 6 says fifth-wheel locking jaws should be around the:
Which release-arm condition is acceptable after coupling?
If the tractor is not lined up with the trailer kingpin before coupling, you should:
The trailer is too high when coupling. What is the main danger?
When raising landing gear after coupling, why secure the crank handle?
Before pulling the fifth-wheel release during uncoupling, you should generally:
After uncoupling, air lines and the electrical cord should be:
When uncoupling on any noticeable grade, the safest added protection is to:
What can happen if the red and blue glad hands are cross-connected?
A glad-hand seal is missing or damaged. What should you expect?
Air and electrical lines should be routed so they:
The tractor protection valve helps protect the tractor by:
The trailer air supply control should pop out when air pressure falls into the manufacturer-specified low range, commonly:
How do you test trailer emergency brakes after charging the trailer air system?
How should trailer service brakes be tested after coupling?
Why should the foot pedal control normal service braking rather than the trailer hand valve?
Loading more…