Question

Practice bulletin: "Grade time (GT) signals control speed on steep grades. When a train enters the timing section in approach to a GT signal, a timer starts. The signal stays red, with its automatic train stop raised, until the timer has run its full time. A train running at or below the posted speed reaches the signal after the timer has run out, so the signal clears and the stop is lowered. A train running too fast reaches the signal while it is still red; if it passes, the raised stop strikes the trip cock on the train and applies the emergency brakes." Based on the bulletin, what happens if a train approaches a GT signal faster than the posted speed and does not stop?

Written Comprehension

Question · Medium

Question

Practice bulletin: "When stopping at a station, the Train Operator must stop the front of the train at the car-stop marker that matches the number of cars in the train (for example, the 8 marker for an 8-car train). If the train stops short of or past the correct marker, the doors must not be opened until the train is properly positioned or the Rail Control Center (RCC) authorizes another action." According to the bulletin, what must happen if a train stops short of its correct car-stop marker?

Written Comprehension

Question · Easy

Question

Practice bulletin: "Every car has emergency brake valves. Opening one vents the brake pipe to the atmosphere, which applies the emergency brakes throughout the train and cuts propulsion. The Train Operator cannot release this application from the cab while the valve is open. After the train stops, the operator must notify the conductor and the Rail Control Center and find out why the valve was opened before recharging the brake pipe." According to the bulletin, why can't the operator release the brakes while an emergency valve is open?

Written Comprehension

Question · Medium

Question

Practice bulletin: "If fire or heavy smoke is seen on or near the roadbed, the Train Operator should stop at the nearest station if it is safe to do so. If the train is between stations and the fire threatens the train, the operator must stop, notify the Rail Control Center (RCC), give the car number, the track number, and the nearest emergency exit or street landmark, and request removal of third-rail power in the affected section." According to the bulletin, which information must the operator give RCC when reporting a fire between stations?

Written Comprehension

Question · Easy

Question

Practice bulletin: "Track workers ahead are protected by flaggers. A yellow flag by day or a yellow light by night means workers are on the track ahead. The Train Operator must acknowledge the flagger with two short horn blasts, reduce to restricted speed (not more than 10 mph), and be prepared to stop. The operator must not pass the flagger until the flagger gives a proceed signal." According to the bulletin, what must the operator do on seeing a flagger's yellow light at night?

Written Comprehension

Question · Medium

Question

Practice bulletin: "When a train is tripped, the Train Operator must inspect the trip cock that was struck. If the trip cock and its lever are intact, the operator may reset it to the running position. If the valve body or its piping is broken, the operator must cut out the damaged equipment as instructed, and the train may then proceed only at restricted speed with Rail Control Center approval." According to the bulletin, when may the operator simply reset the trip cock to the running position?

Written Comprehension

Question · Hard

Question

Practice bulletin: "When a train is laid up in a yard or on a layup track, the operator must make sure it cannot roll away. After stopping, the operator must apply hand brakes on the required number of cars (at least two cars on level track and three on a grade), vent the brake pipe, and check that the brake shoes are pressed against the wheels. Air brakes alone cannot be relied on, because air can leak off over time." According to the bulletin, why must hand brakes be applied on a laid-up train even though the air brakes are applied?

Written Comprehension

Question · Medium

Question

Practice bulletin: "During ice storms, ice can build up on the third rail on outdoor sections and interrupt power to the contact shoes. Operators on outdoor sections should make frequent light brake applications to keep the brake shoes and wheels free of ice, and should avoid stopping on switches and crossovers, where gaps in the third rail can leave the train's contact shoes without power." According to the bulletin, why should an operator avoid stopping on switches and crossovers during an ice storm?

Written Comprehension

Question · Medium

Question

Practice bulletin: "If a person is seen on the roadbed ahead, the operator must sound repeated short horn blasts, stop the train as quickly as possible, and notify the Rail Control Center with the line, track, direction, and nearest station. The operator must ask for third-rail power to be removed from the track the train is on and from adjacent tracks, to protect the person and the responders who will go onto the roadbed." According to the bulletin, why must the operator ask for power removal on adjacent tracks too?

Written Comprehension

Question · Hard

Loading more…