Radon-222, the isotope of primary concern in residential radon mitigation, is produced directly by the radioactive decay of which element?
Radon Science Health
Question · Easy
What is the approximate half-life of radon-222?
The lung-cancer risk from radon exposure is primarily caused by which mechanism?
Question · Medium
Trades Exam Prep Podcast
Listen on Spotify
Podcast
What is the EPA action level at which radon mitigation of a home is recommended?
Using the standard conversion factor, an indoor radon concentration of 4.0 pCi/L is equivalent to approximately how many becquerels per cubic meter (Bq/m3)?
According to EPA estimates, approximately how many lung cancer deaths per year in the United States are attributable to radon?
Assuming the conventional 50% equilibrium ratio, an indoor radon gas concentration of 200 pCi/L corresponds to a decay-product concentration of approximately how many working levels (WL)?
Question · Hard
How does cigarette smoking interact with radon exposure with respect to lung cancer risk?
What is the primary mechanism by which radon enters most homes?
Using the commonly cited transfer rule of thumb, well water containing 10,000 pCi/L of radon will contribute approximately how much radon to the indoor air?
The equilibrium ratio (ER) between radon gas and its short-lived decay products in typical indoor air is approximately:
Which combination of conditions most increases the rate of radon entry into a house?
Before designing a mitigation system for a single-family home, the mitigation specialist should:
Measurement Testing
Per EPA guidance and ANSI-AARST mitigation standards, post-mitigation radon testing should be conducted:
What is the minimum duration of a short-term radon test used to verify mitigation system performance?
For a radon test lasting less than 4 days, closed-building conditions must be established how long before the test begins?
Which placement satisfies radon test device protocol in a home with a finished basement?
Which device is designed for long-term radon measurements of 91 days to one year?
Who should ideally perform the post-mitigation verification test, according to EPA's Consumer's Guide to Radon Reduction?
What is a key advantage of using a continuous radon monitor (CRM) for a post-mitigation test in a real estate transaction?
After a successful mitigation, how often does EPA recommend the home be retested?
Which statement correctly describes activated charcoal radon test devices?
In a measurement quality assurance program, how are duplicate detectors deployed?
Which of the following is an ACCEPTABLE location for deploying a radon test device?
How should severe weather be handled when scheduling a short-term radon test?
What is the first step a mitigation specialist should take when evaluating a home for radon mitigation?
Diagnostics Design
Which procedure correctly describes pressure field extension (PFE) diagnostic testing?
A home has elevated radon and a dirt-floor crawlspace beneath the living area. Which mitigation technique is generally most appropriate?
Which radon reduction technique is the most widely used and generally most effective for existing homes with slab or basement foundations?
Drain-tile depressurization (DTD) is most likely to succeed as the primary suction approach when:
Which statement about block-wall depressurization (BWD) is correct?
PFE diagnostics show very weak communication in tight, damp clay beneath a slab. What design response is most appropriate?
What is the purpose of excavating a suction pit beneath the slab penetration of an ASD system?
Which instrument is appropriate for measuring sub-slab pressure field extension during diagnostics?
With an ASD system operating, chemical smoke is released at a floor-wall joint. Which observation indicates the system is successfully depressurizing the sub-slab area at that location?
When a sump pit is used as the suction point for a radon system, the installation should include:
What is EPA's position on caulking and sealing of entry routes as a stand-alone radon reduction method?
A house has a basement, an adjoining slab-on-grade wing, and a dirt crawlspace. How should mitigation be approached?
A vacuum-cleaner communication test shows a strong pressure response at a test hole near the suction location but no measurable response 25 feet away. What does this indicate?
How does a heat recovery ventilator (HRV) reduce indoor radon?
Other factors being equal, where should a single sub-slab suction point generally be located?
Why is routing the vent pipe through the interior of the house (e.g., through closets to the attic) often preferred over an exterior run in cold climates?
During diagnostics you find the water table seasonally rises to the underside of the slab. How does this affect ASD design?
Which statement best characterizes natural (passive vent) crawlspace ventilation as a radon strategy?
Per ASTM E2121 and ANSI-AARST standards, the radon system discharge point must be at least how far above grade?
Installation Standards
Which discharge separation requirement applies to openings into conditioned spaces (windows, doors, intakes)?
Which of the following fan locations is PROHIBITED by radon mitigation standards?
Loading more…