What does a sound level meter normally measure at the microphone?
Sound Fundamentals
Question · Easy
A 10 dB increase represents what change in acoustic energy or power-related quantity?
Two equal incoherent sound sources each measure 60 dB at the receiver. What is the combined level?
Sound Calculations
Trades Exam Prep Podcast
Listen on Spotify
Podcast
Which weighting approximates human hearing for many occupied-space noise measurements?
Sound Instrumentation
What does Z-weighting mean on a sound level meter?
Why is a field calibrator used before and after a sound survey?
Calibration
Where should a microphone usually be placed for an occupied workstation noise measurement?
Sound Field Practice
What defines an octave band?
Frequency Analysis
What does dBA indicate?
Why measure background noise during a sound test?
Which building system is a common source of sound and vibration complaints?
Building Noise
In building acoustics, what do NC curves rate?
Criteria
Which vibration quantity is commonly used for general rotating-machine severity?
Vibration Fundamentals
A motor runs at 1800 RPM. What is the running speed in Hz?
Vibration Calculations
What does 1X running speed mean in vibration analysis?
Which sensor is commonly used for route-based machine vibration measurements?
Vibration Instrumentation
Which accelerometer mounting method generally gives the best high-frequency response?
Vibration Field Practice
Why trend vibration measurements over time?
Condition Monitoring
Which fault commonly appears as strong 1X radial vibration?
Machine Faults
What is the safest first concern when collecting vibration data near belts or couplings?
Safety
Which item belongs in a measurement report?
Reporting
What is NEBB sound and vibration certification broadly intended to certify?
Nebb Program
Which vibration quantity often emphasizes low-frequency motion?
Which vibration quantity often emphasizes high-frequency impacts?
Which unit is commonly used for vibration velocity in U.S. reports?
What source produces blade-pass frequency?
Why mark vibration measurement locations and directions?
Why use third-octave bands instead of full octave bands?
What should a useful corrective-action report include after an exceedance?
What does a tachometer add to vibration data?
A sound survey records 70 dB with a machine running and 60 dB background. What is the approximate machine-only level?
Question · Medium
A total sound reading is 55 dBA and background is 53 dBA. What is the best interpretation?
Which sound meter workflow is most defensible?
An octave-band spectrum has one band well above adjacent bands. What does that suggest?
Why review C-weighted or Z-weighted levels with A-weighted sound data?
A diffuser is noisy only with a balancing damper nearly closed. What should be investigated first?
Why avoid measuring occupied-space noise very near a reflective wall unless specified?
A fan runs 1200 RPM and has 8 blades. What is blade-pass frequency?
A 1770 RPM motor has a dominant peak near 29.5 Hz. What order is the peak?
Which pattern suggests possible shaft misalignment?
Why is a handheld probe poor for high-frequency bearing analysis?
A route reading rises from 0.08 to 0.16 in/sec RMS at the same point and condition. What should be done?
What operating condition should be controlled when comparing vibration data month to month?
What is true of displacement, velocity, and acceleration?
High-frequency impacts are strong in acceleration but weak in velocity. What should be considered?
Why collect horizontal, vertical, and axial bearing readings?
A pump peak occurs at 5X and the impeller has five vanes. What is likely?
Loading more…