A resistor carries 0.5 A when 12 V is applied across it. What is its resistance?
Electrical Theory
Question · Easy
Three resistors of 10 ohms, 20 ohms, and 30 ohms are connected in series across a 12 V source. What is the total circuit current?
FAA approval for a change to an aeronautical product's original design that also covers how the change affects that design.
Maintenance and regulations
Guess the Term
Chapter 1: Basic Electrical Theory & Systems
1.1 Ohm's Law, Power, and DC Circuit Analysis
Study guide
Two 100 ohm resistors are connected in parallel. What is the equivalent resistance?
Read the clue and guess the term in 6 tries.
Game
A 28 V DC bus supplies a load that draws 7 A. How much power does the load consume?
FAA document that sets the least acceptable performance for an article such as a material, part, component, process, or appliance.
In a capacitor, the property that opposes a change in voltage and stores energy in an electric field is best described as:
In an AC circuit, the total opposition to current flow that combines resistance and reactance is called:
Question · Medium
FAA process under which a company may produce and sell modification and replacement articles for installation on type-certificated products.
1.2 AC Fundamentals, Reactance, and Impedance
A semiconductor diode in a circuit is intended to allow current to flow in only one direction. When the diode is forward biased, the anode is at a potential that is:
Swap tiles to line up three of the same term.
Term Match
Which logic gate produces a HIGH output only when ALL of its inputs are HIGH?
Protective device with a metal element that melts and opens a circuit when current exceeds its rated capacity.
Electrical theory
A technician measures 0 V across a load that should be energized, and full source voltage across an in-line switch that is closed. The most likely fault is:
Question · Hard
The transformer in an avionics power supply has 200 primary turns and 50 secondary turns. If 120 V AC is applied to the primary, the ideal secondary voltage is:
Two-element semiconductor device that uses a PN junction to allow current in only one direction.
1.3 Semiconductor Devices and Power Regulation
VHF communication radios used in civil aviation operate in which frequency band and channel spacing now standard in much of the world?
Cns Systems
Flip two cards at a time to find matching terms.
Term Pairs
A VOR receiver provides which primary information to the pilot?
Electromechanical switch whose electromagnet pulls its arm to open normally closed contacts and close normally open ones when the coil is energized.
An Instrument Landing System (ILS) provides lateral guidance via the localizer and vertical guidance via the:
A Mode S transponder differs from a Mode A/C transponder primarily because it:
Ground navigation aid transmitting in the 108.0 to 117.95 MHz band whose course alignment is generally accurate to plus or minus 1 degree.
Navigation and surveillance
1.4 Digital Logic Gates and Component Identification
ATCRBS and Mode S transponders receive interrogations and transmit replies on which pair of frequencies?
Find five hidden terms in a grid of letters.
Term Search
In the United States, which two ADS-B data links are approved, and which one is restricted to aircraft operating below 18,000 ft?
Approach aid whose localizer gives course guidance to the runway centerline and whose UHF glide slope transmits from 329.15 to 335.00 MHz.
A GPS receiver requires signals from a minimum of how many satellites to compute a three-dimensional position fix (latitude, longitude, and altitude)?
DME (Distance Measuring Equipment) determines distance by measuring:
Airborne unit that times paired pulses returned from a ground transponder and shows only slant-range nautical miles to that ground station, not bearing.
1.5 Aircraft Electrical Power Systems: Batteries, Generation, Buses, and Circuit Protection
An Emergency Locator Transmitter (ELT) meeting current standards and detectable by the Cospas-Sarsat satellite system transmits its primary distress signal on:
A pilot reports the audio panel produces no sidetone when transmitting. Sidetone is best described as:
Airborne safety aid whose version II recommends a climb or descent when another aircraft is a threat, and is required on transport category aircraft and on larger commuter or business aircraft with 31 or more passenger seats.
The pitot-static system supplies ram air pressure to which instrument?
Flight Instruments Pitot Static
Under FAR 91.411 and 91.413, the static pressure system, altimeter, and ATC transponder must each have been tested and inspected within the preceding:
Forward-facing tube that captures dynamic and static pressure for the airspeed indicator.
Flight instruments
Chapter 2: CNS — Communication, Navigation & Surveillance Systems
2.1 Aviation VHF Communications and Audio Integration
An altimeter set to 29.92 in Hg displays pressure altitude. What is this standard setting referred to as?
A gyroscopic attitude indicator in many traditional aircraft is driven by:
Solid-state sensor unit that supplies pitch, bank and compass data to an electronic flight display, replacing free-spinning gyros.
An Air Data Computer (ADC) in a modern glass cockpit primarily processes inputs from:
ARINC 429 is the most common avionics data bus on commercial transport aircraft. Its physical layer is best described as:
Digital Databus
Loading more…