What is the maximum recommended pulling tension for 4-pair UTP copper cable during installation?
Cable Installation
Question · Medium
Which TIA standard governs cabling performance categories and RJ-45 pinout schemes?
Field Planning & Design
Flashcard
Which wiring standard uses the pin/pair assignment of white-orange on pin 1 and orange on pin 2?
Termination
Question · Easy
Gear worn to minimize exposure to hazards that can cause serious work-related injury or illness.
Field planning and safety
Guess the Term
Chapter 1: Codes, Standards, and Certification Overview
1.1 BICSI Installer 1 Exam Overview & Certification Path
Study guide
Cheat sheet
What is the maximum horizontal cable distance specified by TIA-568 for a copper channel?
Standards
Read the clue and guess the term in 6 tries.
Game
A crew documents a new patch-panel port and cable ID on the as-built drawings. Which standard defines this labeling scheme?
What is the minimum bend radius for 4-pair UTP cable during and after installation?
Portable access equipment whose side rails must reach at least 3 feet above an upper landing.
Which NEC article specifically covers communications circuits and cabling?
Codes And Standards
Before pulling the first cable on a new job site, what must an INST1 installer confirm first?
What cable test parameter measures the signal coupling from one pair to an adjacent pair at the near end of the link?
Cable Testing
Rigid structural support that carries electrical cables, raceways, and conductors.
Pathways and spaces
1.2 Telecommunications Codes, Standards & Organizations
A technician is preparing to terminate Cat 6 cable on a patch panel. What is the maximum untwist length allowed at the termination point?
Swap tiles to line up three of the same term.
Term Match
What structural feature distinguishes STP from UTP, and why does it matter during termination?
What type of connector is most commonly used for terminating horizontal copper cabling at the work area outlet?
Supporting device shaped like a J that holds horizontal cables in its opening.
What is the primary purpose of a wiremap test on copper cabling?
A customer needs 10 Gigabit Ethernet over the full 100-meter horizontal run. Which category cable meets this without distance derating?
Which type of punch-down block is most commonly used in modern structured cabling systems for voice and data?
Compartment or chamber connected to one or more air ducts and part of an air distribution system.
1.3 Cable Flammability Ratings & NEC Jacket Classifications
What is the purpose of maintaining a service loop at cable termination points?
Flip two cards at a time to find matching terms.
Term Pairs
Why does an installer read floor-plan blueprint symbols before starting a pull?
A cable tester reports a 'split pair' fault. What does this mean?
Opening, usually circular, through a wall, ceiling, or floor that lets cables pass.
According to BICSI best practices, what is the recommended minimum clearance between copper data cables and fluorescent lighting fixtures?
What's the functional difference between a Telecommunications Room (TR) and an Equipment Room (ER)?
Pathways and Spaces
What is the primary purpose of a cable certification test compared to a verification test?
Single enclosed raceway for conductors or cables.
Chapter 2: Field Planning, Structured Cabling & Blueprints
2.1 Structured Cabling Subsystems & Topologies
What does the NEC require when communications cables pass through a fire-rated wall assembly?
Find five hidden terms in a grid of letters.
Term Search
Where does outside-plant or campus backbone cabling first transition to the building's internal cabling system?
What is the function of a 66 block in telecommunications?
Device that regulates how fast cable pays out from a reel.
Pull cable
What is attenuation in copper cable testing?
A floor's work area totals 1,000 square meters. What's the minimum TR footprint required?
When installing cable in a pathway, what is the maximum recommended fill ratio for conduit?
Amount of extra cable left at a work area after termination, recommended to be at least 305 mm (12 in).
Loading more…